Search results
Results from the WOW.Com Content Network
In 2012, the USB Power Delivery (PD) specification was released. Power Delivery provides the ability for 5 V devices to draw more than 7.5 W of power (the limit specified by USB Battery Charging) from USB PD-aware ports when using PD-aware USB cables. The specification also allows PD ports to provide even greater power at higher voltages over ...
In July 2012, the USB Promoters Group announced the finalization of the USB Power Delivery (USB-PD) specification (USB PD rev. 1), an extension that specifies using certified PD aware USB cables with standard USB Type-A and Type-B connectors to deliver increased power (more than 7.5 W maximum allowed by the previous USB Battery Charging ...
The common EPS specification relies heavily on existing USB electro-mechanical standards – especially the USB Battery Charging Specification. By the mid-2000s, many mobile phone manufacturers (as well as manufacturers of other small battery-powered devices) had already begun designing their products with the ability to use a USB port's 5 V DC ...
USB 3.0 and USB On-The-Go supply 1.8 A/9.0 W (for dedicated battery charging, 1.5 A/7.5 W full bandwidth or 900 mA/4.5 W high bandwidth), while FireWire can in theory supply up to 60 watts of power, although 10 to 20 watts is more typical.
USB 3.2, released in September 2017, fully replaces the USB 3.1 specification. The USB 3.2 specification added a second lane to the Enhanced SuperSpeed System besides other enhancements, so that SuperSpeedPlus USB implements the Gen 2x1 (formerly known as USB 3.1 Gen 2), and the two new Gen 1x2 and Gen 2x2 operation modes while operating on two ...
Some isolated chargers may be used in parallel. This allows for an increased charge current and reduced charging times. The battery has a maximum current rating that cannot be exceeded; Non-isolated: the battery charger has a direct electrical connection to the A/C outlet's wiring. Non-isolated chargers cannot be used in parallel.
The USB PD specification provides the ability for 5 V devices to draw more than (the USB battery-charging specification limit of) 7.5 W of power from USB "PD-aware" ports when using PD-aware USB cables. The specification also allows USB PD ports to provide even greater power at higher voltages over PD-aware cables – up to 36 W at 12 V and 60 ...
Quick Charge is a proprietary technology that can charge battery-powered devices, primarily mobile phones, at power levels exceeding the 7.5 watts (5 volts at 1.5 amps) supported by the USB BC 1.2 standard, using existing USB cables. The higher voltage available allows more power (watts) to be supplied through wires without excessive heating.