Search results
Results from the WOW.Com Content Network
In promiscuous mode, some software might send responses to frames even though they were addressed to another machine. However, experienced sniffers can prevent this (e.g., using carefully designed firewall settings). An example is sending a ping (ICMP echo request) with the wrong MAC address but the right IP address.
Wireshark uses pcap to capture packets, so it can only capture packets on the types of networks that pcap supports. Data can be captured "from the wire" from a live network connection or read from a file of already-captured packets. Live data can be read from different types of networks, including Ethernet, IEEE 802.11, PPP, and loopback.
ECN allows end-to-end notification of network congestion without dropping packets. ECN is an optional feature that may be used between two ECN-enabled endpoints when the underlying network infrastructure also supports it. Conventionally, TCP/IP networks signal congestion by dropping packets.
Limiting the speed of data sent by a data originator (a client computer or a server computer) is much more efficient than limiting the speed in an intermediate network device between client and server because while in the first case usually no network packets are lost, in the second case network packets can be lost / discarded whenever ingoing data speed overcomes the bandwidth limit or the ...
Packet loss occurs when one or more packets of data travelling across a computer network fail to reach their destination. Packet loss is either caused by errors in data transmission, typically across wireless networks, [1] [2] or network congestion. [3]: 36 Packet loss is measured as a percentage of packets lost with respect to packets sent.
Wireshark screenshot of an Ethernet pause frame. Ethernet flow control is a mechanism for temporarily stopping the transmission of data on Ethernet family computer networks. The goal of this mechanism is to avoid packet loss in the presence of network congestion. The first flow control mechanism, the pause frame, was defined by the IEEE 802.3x ...
The original DARPA Internet Protocol's RFC describes [1]: §1.4 TTL as: . The Time to Live is an indication of an upper bound on the lifetime of an internet datagram.It is set by the sender of the datagram and reduced at the points along the route where it is processed.
The "point-to-point protocol" (PPP) is defined by the Internet Request For Comment documents RFC 1570, RFC 1661 and RFC 1662. With respect to the framing of packets, PPP is quite similar to HDLC, but supports both bit-oriented as well as byte-oriented ("octet-stuffed") methods of delimiting frames while maintaining data transparency.