Search results
Results from the WOW.Com Content Network
TARGET2 was the real-time gross settlement (RTGS) system for the Eurozone from its phased introduction in 2007-2008 until its replacement with T2 in March 2023. As such, it was one of the Eurosystem 's TARGET Services , replacing the original TARGET (Trans-European Automated Real-time Gross Settlement Express Transfer System) RTGS introduced in ...
As of late 2024, TARGET Services included T2 for large payments (which replaced TARGET2 in 2023), TARGET2-Securities (T2S) for securities transactions, and TARGET Instant Payment Settlement (TIPS) for instant payments. [1] [2] A fourth service, the Eurosystem Collateral Management System (ECMS), is to complement the TARGET suite in mid-June ...
An ICD is the umbrella document over the system interfaces; examples of what these interface specifications should describe include: The inputs and outputs of a single system, documented in individual SIRS (Software Interface Requirements Specifications) and HIRS (Hardware Interface Requirements Specifications) documents, would fall under "The Wikipedia Interface Control Document".
Network planning and design is an iterative process, encompassing topological design, network-synthesis, and network-realization, and is aimed at ensuring that a new telecommunications network or service meets the needs of the subscriber and operator. [1] The process can be tailored according to each new network or service. [2]
Carrier-grade NAT. Carrier-grade NAT (CGN or CGNAT), also known as large-scale NAT (LSN), is a type of network address translation (NAT) used by ISPs in IPv4 network design. With CGNAT, end sites, in particular residential networks, are configured with private network addresses that are translated to public IPv4 addresses by middlebox network address translator devices embedded in the network ...
There are many different ways to measure the performance of a network, as each network is different in nature and design. Performance can also be modeled and simulated instead of measured; one example of this is using state transition diagrams to model queuing performance or to use a Network Simulator.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
In computer networking, the interpacket gap (IPG), also known as interframe spacing, or interframe gap (IFG), is a pause which may be required between network packets or network frames.