enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nylon 12 - Wikipedia

   en.wikipedia.org/wiki/Nylon_12

   Nylon 12 exhibits properties between short chain aliphatic nylons (e.g., nylon 6 and nylon 66) and polyolefins. [3] At 178-180 °C, the melting point of nylon 12 is the lowest among the important polyamides. Its mechanical properties, such as hardness, tensile strength, and resistance to abrasion, are similar to those of nylon 6 and nylon 66.

3. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   The other goal of a hose clamp is to provide mechanical attachment keeping the hose attached to a barb, hose nipple, or tube. To do this the clamp is typically placed on the hose behind the first ramp of the barb or behind the raised area near the end of and completely around the circumference of the hose nipple or tube called a bead.

4. Nylon 11 - Wikipedia

   en.wikipedia.org/wiki/Nylon_11

   Nylon 11 or Polyamide 11 (PA 11) is a polyamide, bioplastic and a member of the nylon family of polymers produced by the polymerization of 11-aminoundecanoic acid. It is produced from castor beans by Arkema under the trade name Rilsan .

5. Materials for use in vacuum - Wikipedia

   en.wikipedia.org/wiki/Materials_for_use_in_vacuum

   Nylon is self-lubricating but has high outgassing rate and high affinity to water. Acrylics have high outgassing rate and high affinity to water. Polycarbonates and polystyrene are good electrical insulators with moderate outgassing.

6. Nylon - Wikipedia

   en.wikipedia.org/wiki/Nylon

   Nylon was the first commercially successful synthetic thermoplastic polymer. [12] DuPont began its research project in 1927. [ 9 ] The first nylon, nylon 66 , was synthesized on February 28, 1935, by Wallace Hume Carothers at DuPont's research facility at the DuPont Experimental Station .

7. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in 1 ⁄ 16-inch increments. Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness.