enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Metal roof - Wikipedia

   en.wikipedia.org/wiki/Metal_roof

   Standing seam metal roofs can have a lower pitch than asphalt shingle roofs because shingled roofs need a higher pitch to keep the wind from blowing up the shingles and potentially blowing them off in high winds. Standing seam metal roofs come in sheets up to or sometimes more than 30 feet (9.1 m) long and widths of 12, 14, 16 or 18 inches (300 ...

3. List of commercially available roofing materials - Wikipedia

   en.wikipedia.org/wiki/List_of_commercially...

   Standing-seam metal roof with concealed fasteners. Mechanically seamed metal with concealed fasteners contains sealant in seams for use on very low sloped roofs, suitable for roofs of low pitch such as 0.5/12 to 3/12 pitch. Flat-seam metal with or without soldered seams. Steel coated with a coloured alloy of zinc and aluminium. Stone-coated ...

4. Flat roof - Wikipedia

   en.wikipedia.org/wiki/Flat_roof

   A study by Ducker International in 2005 identified the average cost per year of a metal roof to be US$3.2 per square metre ($0.30/sq ft) while single-ply roofs stood at $6.1/m 2 ($0.57/sq ft) and built-up roofing at $4.0/m 2 ($0.37/sq ft).

5. Asphalt shingle - Wikipedia

   en.wikipedia.org/wiki/Asphalt_shingle

   Asphalt shingles on a home in Avalon, New Jersey. Two types of base materials are used to make asphalt shingles, organic and fiberglass.Both are made in a similar manner, with an asphalt-saturated base covered on one or both sides with asphalt or modified-asphalt, the exposed surface impregnated with slate, schist, quartz, vitrified brick, stone, [6] or ceramic granules, and the under-side ...

6. Domestic roof construction - Wikipedia

   en.wikipedia.org/wiki/Domestic_roof_construction

   Ventilation of the roof deck speeds the evaporation of water from leakage or condensation and removes heat which helps prevent ice dams and helps asphalt shingles last longer. Building codes in the U.S. specify ventilation rates as a minimum of 1 sq ft (0.093 m 2 ) of opening per 150 sq ft (14 m 2 ) (1:150) with a ratio of 1:300 in some ...

7. Hemming and seaming - Wikipedia

   en.wikipedia.org/wiki/Hemming_and_seaming

   hemming process A closed hem A seam. Hemming and seaming are two similar metalworking processes in which a sheet metal edge is rolled over onto itself. Hemming is the process in which the edge is rolled flush to itself, while a seam joins the edges of two materials.