Ads
related to: water tank rubber bungs screwfix connectors
Search results
Results from the WOW.Com Content Network
Tank connectors are a type of tank fitting also known as tank inlets, tank outlets, or tank nipples. This fitting must be leakage proof, as the water supply (inward and outward) depends on same. Many different varieties of tank connectors exist. Tank connectors are widely made of plastic (PVC) or brass. They have a flange either on the edge of ...
Nipple. In plumbing and piping, a nipple is a fitting, consisting of a short piece of pipe, usually provided with a male pipe thread at each end, for connecting two other fittings. The length of the nipple is usually specified by the overall length with thread. It may have a hexagonal section in the center for a wrench to grasp (sometimes ...
Copper fittings for soldered joints. Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters. PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube ...
A bung can be defined as "a plug or closure used to close an opening in a drum or barrel. It is called a plug when referring to a steel drum closure." [1] A glass stopper is often called a "ground glass joint" (or "joint taper"), and a cork stopper is called simply a "cork". Stoppers used for wine bottles are referred to as "corks", even when ...
A laboratory rubber stopper or a rubber bung or a rubber cork is mainly used in chemical laboratories in combination with flasks and test tube and also for fermentation in winery. [ 1 ][ 2 ][ 3 ] Generally, in a laboratory, the sizes of rubber stoppers can be varied up to approximately 16 sizes and each of it is specific to certain type of ...
A backflow prevention device is used to protect potable water supplies from contamination or pollution due to backflow. In water distribution systems, water is normally maintained at a significant pressure to enable water to flow from the tap, shower, or other fixture. Water pressure may fail or be reduced when a water main bursts, pipes freeze ...
A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect
Crude versions of conically tapered ground glass joints have been made for quite a while, [1] particularly for stoppers for glass bottles and retorts. [2] Crude glass joints could still be made to seal well by grinding the two parts of a joint against each other using an abrasive grit, but this led to variations between joints and they would not seal well if mated to a different joint.
Ads
related to: water tank rubber bungs screwfix connectors