Search results
Results from the WOW.Com Content Network
In some pendulum clocks, fine adjustment is done with an auxiliary adjustment, which may be a small weight that is moved up or down the pendulum rod. In some master clocks and tower clocks, adjustment is accomplished by a small tray mounted on the rod where small weights are placed or removed to change the effective length, so the rate can be ...
Turning the nut adjusts the height of the bob. But some bobs have levers or dials to adjust the height. In some precision clocks there is a smaller auxiliary weight on a threaded shaft to allow more fine adjustment. Tower clocks sometimes have a tray mounted on the pendulum rod, to which small weights can be added or removed, to adjust the rate ...
A grandfather clock (also a longcase clock, tall-case clock, grandfather's clock, hall clock or floor clock) is a tall, freestanding, weight-driven pendulum clock, with the pendulum held inside the tower or waist of the case. Clocks of this style are commonly 1.8–2.4 metres (6–8 feet) tall with an enclosed pendulum and weights, suspended by ...
The clock can be made faster or slower by an adjustment screw mechanism on the torsion pendulum that moves the weight balls in or out from the axis. The closer in the balls are, the smaller the moment of inertia of the torsion pendulum and the faster it will turn, what causes the clock to speed up.
The foliot was a horizontal bar with weights near its ends affixed to a vertical bar called the verge which was suspended free to rotate. The verge escapement caused the foliot to oscillate back and forth about its vertical axis. [12] The rate of the clock could be adjusted by moving the weights in or out on the foliot.
Huygens' maintaining power in use. The weight drive used by Christiaan Huygens in his early clocks acts as a maintaining power. In this layout, the weight which drives the clock is carried on a pulley and the cord (or chain) supporting the weight is wrapped around the main driving wheel on one side and the rewinding wheel on the other.
In order to adjust the rate, the balance spring usually has a regulator. The regulator is a moveable lever mounted on the balance cock or bridge, pivoted coaxially with the balance. A narrow slot is formed on one end of the regulator by two downward projecting pins, called curb pins, or by a curb pin and a pin with a heavier section called a boot.
The backward motion of the escape wheel during part of the cycle, called recoil, is one of the disadvantages of the anchor escapement.It results in a temporary reversal of the entire wheel train back to the driving weight with each tick of the clock, causing extra wear in the wheel train, excessive wear to the gear teeth, and inaccuracy.