Search results
Results from the WOW.Com Content Network
Clock signal and legend. In electronics and especially synchronous digital circuits, a clock signal (historically also known as logic beat) [1] is an electronic logic signal (voltage or current) which oscillates between a high and a low state at a constant frequency and is used like a metronome to synchronize actions of digital circuits.
A clock generator is an electronic oscillator that produces a clock signal for use in synchronizing a circuit's operation. The output clock signal can range from a simple symmetrical square wave to more complex arrangements. The basic parts that all clock generators share are a resonant circuit and an amplifier.
A timing diagram can contain many rows, usually one of them being the clock. It is a tool commonly used in digital electronics, hardware debugging, and digital communications. Besides providing an overall description of the timing relationships, the digital timing diagram can help find and diagnose digital logic hazards .
A flipflop-based dual-rank synchronizer can be used to synchronize an external trigger to a counter-based delay generator, as in case (1) above. It is then possible to measure the skew between the input trigger and the local clock and adjust the vernier delay on a shot-by-shot basis, to compensate for most of the trigger-to-clock jitter.
Digital pattern generators are today available as stand-alone units, add-on hardware modules for other equipment such as a [logic analyzer] or as PC-based equipment.. Stand-alone units are self-contained devices that include everything from the user interface to define the patterns that should be generated to the electronic equipment that actually generates the output signal.
In this image, the lower signal is the clock and the upper signal is the data. Data is recognized by the circuit at the positive edge of the clock. There are two time intervals illustrated in this image. One is the setup time, and the other is the timing margin. The setup time is illustrated in red in this image; the timing margin is ...
One drawback of using source-synchronous clocking is the creation of a separate clock-domain at the receiving device, namely the clock-domain of the strobe generated by the transmitting device. This strobe clock-domain is often not synchronous to the core clock domain of the receiving device. For proper operation of the received data with other ...
A DLL can be used to change the phase of a clock signal (a signal with a periodic waveform), usually to enhance the clock rise-to-data output valid timing characteristics of integrated circuits (such as DRAM devices). DLLs can also be used for clock recovery (CDR). From the outside, a DLL can be seen as a negative delay gate placed in the clock ...