Search results
Results from the WOW.Com Content Network
Thermodynamic data is usually presented as a table or chart of function values for one mole of a substance (or in the case of the steam tables, one kg). A thermodynamic datafile is a set of equation parameters from which the numerical data values can be calculated. Tables and datafiles are usually presented at a standard pressure of 1 bar or 1 ...
When steam has reached this equilibrium point, it is referred to as saturated steam. Superheated steam or live steam is steam at a temperature higher than its boiling point for the pressure, which only occurs when all liquid water has evaporated or has been removed from the system.
The Mollier enthalpy–entropy diagram for water and steam. The "dryness fraction", x , gives the fraction by mass of gaseous water in the wet region, the remainder being droplets of liquid. An enthalpy–entropy chart , also known as the H – S chart or Mollier diagram , plots the total heat against entropy, [ 1 ] describing the enthalpy of a ...
The above expression for vapor quality can be expressed as: = where is equal to either specific enthalpy, specific entropy, specific volume or specific internal energy, is the value of the specific property of saturated liquid state and is the value of the specific property of the substance in dome zone, which we can find both liquid and vapor .
If specific heat is expressed per mole of atoms for these substances, none of the constant-volume values exceed, to any large extent, the theoretical Dulong–Petit limit of 25 J⋅mol −1 ⋅K −1 = 3 R per mole of atoms (see the last column of this table). For example, Paraffin has very large molecules and thus a high heat capacity per mole ...
On the other hand, some constants, such as K f (the freezing point depression constant, or cryoscopic constant), depend on the identity of a substance, and so may be considered to describe the state of a system, and therefore may be considered physical properties. "Specific" properties are expressed on a per mass basis.
CRC Press. Boca Raton, Florida, 2003; Section 4, Properties of the Elements and Inorganic Compounds; Vapor Pressure of the Metallic Elements The equations reproduce the observed pressures to an accuracy of ±5% or better. Coefficients from this source: Alcock, C. B.; Itkin, V. P.; Horrigan, M. K. (1984).
The table values for −100 °C to 100 °C were computed by the following formulas, where T is in kelvins and vapor pressures, P w and P i, are in pascals. Over liquid water log e ( P w ) = −6094.4642 T −1 + 21.1249952 − 2.724552×10 −2 T + 1.6853396×10 −5 T 2 + 2.4575506 log e ( T )