enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Resistance thermometer - Wikipedia

    en.wikipedia.org/wiki/Resistance_thermometer

    By far the most common devices used in industry have a nominal resistance of 100 ohms at 0 °C and are called Pt100 sensors ("Pt" is the symbol for platinum, "100" for the resistance in ohms at 0 °C). It is also possible to get Pt1000 sensors, where 1000 is for the resistance in ohms at 0 °C.

  3. Callendar–Van Dusen equation - Wikipedia

    en.wikipedia.org/wiki/Callendar–Van_Dusen_equation

    The Callendar–Van Dusen equation is an equation that describes the relationship between resistance (R) and temperature (T) of platinum resistance thermometers (RTD). As commonly used for commercial applications of RTD thermometers, the relationship between resistance and temperature is given by the following equations.

  4. Beckmann thermometer - Wikipedia

    en.wikipedia.org/wiki/Beckmann_thermometer

    A Beckmann thermometer is a device used to measure small differences of temperature, but not absolute temperature values. It was invented by Ernst Otto Beckmann (1853 – 1923), a German chemist, for his measurements of colligative properties in 1905. [1] Today its use has largely been superseded by platinum PT100 resistance thermometers and ...

  5. List of temperature sensors - Wikipedia

    en.wikipedia.org/wiki/List_of_temperature_sensors

    The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...

  6. Steinhart–Hart equation - Wikipedia

    en.wikipedia.org/wiki/Steinhart–Hart_equation

    is a reference (standard) resistance value. The Steinhart–Hart equation assumes is 1 ohm. The curve fit is much less accurate when it is assumed = and a different value of such as 1 kΩ is used. However, using the full set of coefficients avoids this problem as it simply results in shifted parameters.

  7. International Temperature Scale of 1990 - Wikipedia

    en.wikipedia.org/wiki/International_Temperature...

    These include helium vapor pressure thermometers, helium gas thermometers, standard platinum resistance thermometers (known as SPRTs) and monochromatic radiation thermometers. Although the Kelvin and Celsius temperature scales were (until 2019) defined using the triple point of water ( 273.16 K or 0.01 °C ), it is impractical to use this ...

  8. PT100 - Wikipedia

    en.wikipedia.org/wiki/PT100

    Download as PDF; Printable version; In other projects ... Appearance. move to sidebar hide. PT100 or PT-100 may refer to: A type of the ... A type of resistance ...

  9. List of thermal conductivities - Wikipedia

    en.wikipedia.org/wiki/List_of_thermal_conductivities

    Sapphire values are taken from Kingery, W.D. and Norton, F.H., USAEC Rept. NYO-6447, 1–14, 1955, TPRC II pages 94, 96, curve 19 ref. 72 page 1160. [32] Errata: The numbered references in the NSRDS-NBS-8 pdf are found near the end of the TPRC Data Book Volume 2 and not somewhere in Volume 3 like it says. [32] Aluminium oxide, porous 22% ...