Search results
Results from the WOW.Com Content Network
A nautical mile is a unit of length used in air, marine, and space navigation, and for the definition of territorial waters. [2] [3] [4] Historically, it was defined as the meridian arc length corresponding to one minute ( 1 / 60 of a degree) of latitude at the equator, so that Earth's polar circumference is very near to 21,600 nautical miles (that is 60 minutes × 360 degrees).
Nautical mile: Length: Rhumb: Angle: The angle between two successive points of the thirty-two point compass (11 degrees 15 minutes) (rare) [1] Shackle: Length: Before 1949, 12.5 fathoms; later 15 fathoms. [2] Toise: Length: Toise was also used for measures of area and volume Twenty-foot equivalent unit or TEU: Volume: Used in connection with ...
These instruments are also used to measure the angular distance between objects: Octant, invented in 1731. The first widely accepted instrument that could measure an angle without being strongly affected by movement. Sextant, derived from the octant in 1757, eventually made all previous instruments used for the same purpose obsolete.
This means that east–west distances are exaggerated at high latitudes. To keep the projection conformal, the projection increases the displayed distance between lines of latitude (north–south distances) in proportion; thus a square is shown as a square everywhere on the chart, but a square on the Arctic Circle appears much bigger than a ...
In nautical navigation the absolute bearing is the clockwise angle between north and an object observed from the vessel. If the north used as reference is the true geographical north then the bearing is a true bearing whereas if the reference used is magnetic north then the bearing is a magnetic bearing .
To accurately measure performance ships must make at least four to six runs in both directions to allow for the wind and tide. [1] There are several nautical measured miles around the British Isles: Between Talland Bay and Hannafore, West Looe, Cornwall. [2] At Skelmorlie, North Ayrshire, Scotland, between Skelmorlie Pier and Skelmorlie Castle. [3]
The length of the internationally agreed nautical mile is 1 852 m. The US adopted the international definition in 1954, having previously used the US nautical mile (1 853.248 m). [6] The UK adopted the international nautical mile definition in 1970, having previously used the UK Admiralty nautical mile (6 080 ft or 1 853.184 m).
The length of the line on the linear scale is equal to the distance represented on the earth multiplied by the map or chart's scale. In most projections, scale varies with latitude, so on small scale maps, covering large areas and a wide range of latitudes, the linear scale must show the scale for the range of latitudes covered by the map. One ...