Search results
Results from the WOW.Com Content Network
Regelation is the phenomenon of ice melting under pressure and refreezing when the pressure is reduced. This can be demonstrated by looping a fine wire around a block of ice, with a heavy weight attached to it. The pressure exerted on the ice slowly melts it locally, permitting the wire to pass through the entire block.
The Wegener–Bergeron–Findeisen process (after Alfred Wegener, Tor Bergeron, and Walter Findeisen []), (or "cold-rain process") is a process of ice crystal growth that occurs in mixed phase clouds (containing a mixture of supercooled water and ice) in regions where the ambient vapor pressure falls between the saturation vapor pressure over water and the lower saturation vapor pressure over ice.
As a glacier moves down a valley, friction causes the basal ice of the glacier to melt and infiltrate joints (cracks) in the bedrock. The freezing and thawing action of the ice enlarges, widens, or causes further cracks in the bedrock as it changes volume across the ice/water phase transition (a form of hydraulic wedging), gradually loosening ...
Because ice XI can theoretically form at low pressures at temperatures between 50–70 K – temperatures present in astrophysical environments of the outer solar system and within permanently shaded polar craters on the Moon and Mercury. Ice XI forms most easily around 70 K – paradoxically, it takes longer to form at lower temperatures.
Ice dams on roofs form when accumulated snow on a sloping roof melts and flows down the roof, under the insulating blanket of snow, until it reaches below freezing temperature air, typically at the eaves. When the meltwater reaches the freezing air, ice accumulates, forming a dam, and snow that melts later cannot drain properly through the dam ...
Graupel (/ ˈ ɡ r aʊ p əl /; German: [ˈɡʁaʊpl̩] ⓘ), also called soft hail or hominy snow or granular snow or snow pellets, [1] is precipitation that forms when supercooled water droplets in air are collected and freeze on falling snowflakes, forming 2–5 mm (0.08–0.20 in) balls of crisp, opaque rime.
Melt Forms (MF) – Range from clustered round grains of wet snow through melt-freeze rounded polycrystals when water in veins freezes to loosely bonded, fully rounded single crystals and polycrystals.to polycrystals from a surface layer of wet snow that refroze after having been wetted by melt or rainfall. Ice Formations (IF) – Encompass the ...
The classical Stefan problem aims to describe the evolution of the boundary between two phases of a material undergoing a phase change, for example the melting of a solid, such as ice to water. This is accomplished by solving heat equations in both regions, subject to given boundary and initial conditions.