Ad
related to: x10 modules to control lights
Search results
Results from the WOW.Com Content Network
Many device modules offer a feature called local control. If the module is switched off, operating the power switch on the lamp or appliance will cause the module to turn on. In this way, a lamp can still be lit or a coffee pot turned on without the need to use an X10 controller. Wall switch modules may not offer this feature.
Possibility to query the status of a module (for example to determine if a device is switched on or what the dim level of a light is) Possibility to monitor the noise and signal levels per module; Fast: the time between the sending of a command and the retuning of an ACK is ~500 ms [8] Scalability: up to 64000 modules can be addressed.
The term lighting control system refers to an intelligent networked system of devices related to lighting control. These devices may include relays, occupancy sensors, photocells, light control switches or touchscreens, and signals from other building systems (such as fire alarm or HVAC). Adjustment of the system occurs both at device locations ...
Some examples of actions that can be achieved without a hub or controller would be: timed shutoff of a bathroom fan (timer plug-in module or a switch with timer feature built-in), lights turning on or off based on a photocell's sensing of sunlight (I/O plug-in module), turning on one set of lights with a single tap of the switch and turning on ...
Each channel supports smart boards [11] to add serial communication for microcontrollers such as Arduino or BASIC Stamp, servo control, or X10 outlet and light control. The module provides 1 KB of on-board logic storage for rules defined by the user.
Insteon is a proprietary home automation (domotics) system that enables light switches, lights, leak sensors, remote controls, motion sensors, and other electrically powered devices to interoperate through power lines, radio frequency (RF) communications, or both.
C-Bus is used in the control of domotics, or home automation systems, as well as commercial building lighting control systems. Unlike the more common X10 protocol which uses a signal imposed upon the AC power line, C-Bus uses a dedicated low-voltage cable or two-way wireless network to carry command and control signals. This improves the ...
Dimmer light switch with RF-based remote control [1] A wireless light switch is a light switch that commands a light or home appliance to turn itself off or on, instead of interrupting the power line going to the light fixture. There are different ways to communicate between the switch and the fixture: [2]
Ad
related to: x10 modules to control lights