Search results
Results from the WOW.Com Content Network
Typical rivet nut Sectional view Sectional view, with bolt inserted. A rivet nut, also known as a blind rivet nut, or rivnut, [1] is a one-piece internally threaded and counterbored tubular rivet that can be anchored entirely from one side. It is a kind of threaded insert. There are two types: one is designed to form a bulge on the back side of ...
Crown hex nut, blind nut, cap nut, domed cap nut, or dome nut A nut that has a domed end on one side Barrel nut: Steel cross dowel or dowel nut, cross dowel (woodworking) A round slug or formed sheet metal part with threads perpendicular to the length of the nut Cage nut: Caged nut, captive nut, clip nut
The tapped hole (or nut) into which the screw fits, has an internal diameter which is the size of the screw minus the pitch of the thread. Thus, an M6 screw, which has a pitch of 1 mm, is made by threading a 6 mm shank, and the nut or threaded hole is made by tapping threads into a hole of 5 mm diameter (6 mm − 1 mm).
T-nuts. The left one has been inserted in the wood and a bolt has been screwed in from the other side. A T-nut, T nut, or tee nut (also known as a blind nut, [1] which can however also refer to a rivet nut or an insert nut, and likewise drive-in nut [2]) is a type of nut used to fasten a wood, particle or composite materials workpiece, leaving a flush surface.
It indicates the diameter of smooth-walled hole that a male thread (e.g. on a bolt) will pass through easily to connect to an internally threaded component (e.g. a nut) on the other side. For example, an M6 screw has a nominal outer diameter of 6 millimetres and will therefore be a well-located, co-axial fit in a hole drilled to 6 mm diameter.
A nyloc nut, also referred to as a nylon-insert lock nut, polymer-insert lock nut, or elastic stop nut, is a kind of locknut with a nylon collar that increases friction on the screw thread. The nylon collar insert is placed at the end of the nut, with an inner diameter (ID) slightly smaller than the major diameter of the screw.
Drawing of round head rivets, 1898 A typical technical drawing of a universal head solid rivet Riveters work on the Liberty ship SS John W. Brown (December 2014).. Rivet holes have been found in Egyptian spearheads dating back to the Naqada culture of between 4400 and 3000 B.C. Archeologists have also uncovered many Bronze Age swords and daggers with rivet holes where the handles would have been.
A common use for cage nuts is to mount equipment in square-holed 19-inch racks (the most common type), with 0.375 inches (9.5 mm) square-hole size. There are four common sizes: UNF 10–32 and, to a lesser extent, UNC 12–24 are generally used in the United States; elsewhere, M5 (5 mm outside diameter and 0.8 mm pitch) for light and medium equipment and M6 for heavier equipment, such as servers.