Search results
Results from the WOW.Com Content Network
On sandy loam soils, the infiltration rate under a litter cover can be nine times higher than on bare surfaces. The low rate of infiltration in bare areas is due mostly to the presence of a soil crust or surface seal. Infiltration through the base of a tuft is rapid and the tufts funnel water toward their own roots. [6]
These soils have a moderate rate of water transmission (final infiltration rate of 0.15–0.30 in (3.8–7.6 mm) per hour). HSG Group C: Soils with slow infiltration rates when thoroughly wetted. These consist chiefly of soils with a layer that impedes downward movement of water or soils with moderately fine to fine textures.
This residual water moisture affects the soil's infiltration capacity. During the next rainfall event, the infiltration capacity will cause the soil to be saturated at a different rate. The higher the level of antecedent soil moisture, the more quickly the soil becomes saturated. Once the soil is saturated, runoff occurs.
Chemical decomposition is a function of mineral solubility, the rate of which doubles with each 10 °C rise in temperature but is strongly dependent on water to effect chemical changes. Rocks that will decompose in a few years in tropical climates will remain unaltered for millennia in deserts. [23]
There are various factors that affect soil temperature, such as water content, [84] soil color, [85] and relief (slope, orientation, and elevation), [86] and soil cover (shading and insulation), in addition to air temperature. [87] The color of the ground cover and its insulating properties have a strong influence on soil temperature. [88]
Groundwater entering sanitary sewers through defective pipe joints and broken pipes is called infiltration. [4] Pipes may leak because of careless installation; they may also be damaged after installation by differential ground movement, heavy vehicle traffic on roadways above the sewer, careless construction practices in nearby trenches, or degradation of the sewer pipe materials.
Rates of groundwater recharge are difficult to quantify. [13] [2] This is because other related processes, such as evaporation, transpiration (or evapotranspiration) and infiltration processes must first be measured or estimated to determine the balance. There are no widely applicable method available that can directly and accurately quantify ...
Soil chemistry is the study of the chemical characteristics of soil.Soil chemistry is affected by mineral composition, organic matter and environmental factors. In the early 1870s a consulting chemist to the Royal Agricultural Society in England, named J. Thomas Way, performed many experiments on how soils exchange ions, and is considered the father of soil chemistry. [1]