Search results
Results from the WOW.Com Content Network
In surface water hydrology and civil engineering, drawdown refers to the lowering of the surface elevation of a body of water, the water table, the piezometric surface, or the water surface of a well, as a result of the withdrawal of water. [1] In either case, drawdown is the change in hydraulic head or water level relative to the initial ...
In hydrology, a well test is conducted to evaluate the amount of water that can be pumped from a particular water well.More specifically, a well test will allow prediction of the maximum rate at which water can be pumped from a well, and the distance that the water level in the well will fall for a given pumping rate and duration of pumping.
The source and sink composite curves is a graphical tool for setting water recovery targets as well as for design of water recovery networks. [5] A 2018 study found by water pinch and water footprint analysis that for bricks with typical materials of clay and shale, the water consumption footprint was 2.02 L of water per brick. [6]
Pumps being used to dewater a spillway at Baldhill Dam. Dewatering / d iː ˈ w ɔː t ər ɪ ŋ / is the removal of water from a location. This may be done by wet classification, centrifugation, filtration, or similar solid-liquid separation processes, such as removal of residual liquid from a filter cake by a filter press as part of various industrial processes.
Water cooling is a method of heat removal from components of machinery and industrial equipment. Water may be a more efficient heat transfer fluid where air cooling is ineffective. In most occupied climates water offers the thermal conductivity advantages of a liquid with unusually high specific heat capacity and the option that of evaporative ...
Steam and water analysis system (SWAS) [1] is a system dedicated to the analysis of steam or water. In power stations , it is usually used to analyze boiler steam and water to ensure the water used to generate electricity is clean from impurities which can cause corrosion to any metallic surface, such as in boiler and turbine .
Manufacturing process management (MPM) is a collection of technologies and methods used to define how products are to be manufactured. MPM differs from ERP/MRP which is used to plan the ordering of materials and other resources, set manufacturing schedules, and compile cost data.
Drawdown (climate), the point at which greenhouse gas concentrations in the atmosphere begin to decline; Drawdown (economics), decline in the value of an investment, below its all-time high; Drawdown (hydrology), a lowering of a reservoir or a change in hydraulic head in an aquifer, typically due to pumping a well