Search results
Results from the WOW.Com Content Network
In computer networking, multicast is a type of group communication where data transmission is addressed to a group of destination computers simultaneously. [1] Multicast can be one-to-many or many-to-many distribution. [2] [3] Multicast differs from physical layer point-to-multipoint communication.
The protocol definition was developed in the Multicast Security Workgroup and led to several Request for Comments (RFC) that are now used as standards for securing IP multicast traffic. The protocol allowed a sender to encrypt the multicast packet and forward it into the packet network on the optimal distribution tree.
Broadcast traffic is reduced and VXLAN tunnel endpoints (VTEPs) reply to the caller directly. VXLAN can handle BUM in two ways: Multicast and Head End Replication. Multicast is the most common approach, and each VXLAN network identifier (VNI) is mapped to a single multicast group, while each multicast group may map to one or more VNIs.
Protocol Independent Multicast (PIM) is then used between the local and remote multicast routers to direct multicast traffic from hosts sending multicasts to hosts that have registered through IGMP to receive them. IGMP operates on the network layer (layer 3), just the same as other network management protocols like ICMP. [1]
To implement the multicast routing, Internet Group Management Protocol (IGMP) and a multicast routing protocol (Reverse-path forwarding, PIM-SM) for registration subscriber grouping and control traffic are required for multicast transmission. [2] [3] [4] Regarding IP multicast, it is a technique for one-to-many communication over an IP network ...
A multicast address is a logical identifier for a group of hosts in a computer network that are available to process datagrams or frames intended to be multicast for a designated network service. Multicast addressing can be used in the link layer (layer 2 in the OSI model ), such as Ethernet multicast, and at the internet layer (layer 3 for OSI ...
RFC 2722 defines traffic flow as "an artificial logical equivalent to a call or connection." [1] RFC 3697 defines traffic flow as "a sequence of packets sent from a particular source to a particular unicast, anycast, or multicast destination that the source desires to label as a flow. A flow could consist of all packets in a specific transport ...
Dense mode multicast is one mode that multicast can use to construct a tree for sending packets to the multicast subscribers. It is an alternative to sparse mode. The basic assumption behind dense mode is that the multicast packet stream has receivers at most locations. Sparse mode assumes relatively fewer receivers.