Search results
Results from the WOW.Com Content Network
Static routing may have the following uses: When using static address configuration (in the absence of DHCP or Router Advertisements) it can be used to provide a default route, forming a special case of the longest prefix match as it has a prefix length of zero and therefore always matches, and always matches last.
Router R1 is a one-armed router carrying out inter-VLAN routing. A router on a stick, also known as a one-armed router, [1] [2] is a router that has a single physical or logical connection to a network. It is a method of inter-VLAN routing where one router is connected to a switch via a single cable. The router has physical connections to the ...
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.
Here is a typical configuration: A local network uses one of the designated private IP address subnets (RFC 1918 [5]). The network has a router having both a private and a public address. The private address is used by the router for communicating with other devices in the private local network.
A BOOTP configuration server replies to the request by assigning an IP address from a pool of addresses, which is preconfigured by an administrator. BOOTP is implemented using the User Datagram Protocol (UDP) for transport. Port number 67 is used by the server for receiving client requests, and port number 68 is used by the client for receiving ...
Radvd answers requests with router advertisement (RA) messages. In addition, radvd periodically multicasts RA packets to the attached link to update network hosts. The router advertisement messages contain the routing prefix used on the link, the link maximum transmission unit (MTU), and the address of the responsible default router.
Port Control Protocol (PCP) is a computer networking protocol that allows hosts on IPv4 or IPv6 networks to control how the incoming IPv4 or IPv6 packets are translated and forwarded by an upstream router that performs network address translation (NAT) or packet filtering.
The label edge routers at the edges of an MPLS cloud map between the end-to-end identifier, such as an IP address, and a link-local label. At each MPLS hop, there is a forwarding table that tells the label-switched router which outgoing interface is to receive the MPLS packet, and what label to use when sending the packet out that interface.