Search results
Results from the WOW.Com Content Network
A BNC inserter/remover tool, also called a BNC tool, BNC extraction tool, BNC wrench, or BNC apple corer, is a tool used to insert or remove BNC connectors in high density or hard-to-reach locations, such as densely wired patch panels in broadcast facilities like central apparatus rooms.
SR connector (from Russian: Cоединитель Pадиочастотный) is a Russian RF connector, based on the BNC connector and which comes in a 50 Ω and 75 Ω versions; TNC connector (threaded Neill-Concelman) Twin-BNC (Twinax) Twinax connectors are used with 78 Ω or 95 Ω conductor cables and operate from 0–200 MHz. Due to ...
The lead wire is a coated copper wire, a tinned copper wire or another electrically conductive wire used to connect two locations electrically. In electronics, a lead (/ ˈ l iː d /) or pin is an electrical connector consisting of a length of wire or a metal pad (surface-mount technology) that is designed to connect two locations electrically.
No hub is required as with 10BASE-T, so the hardware cost was minimal, and wiring was particularly easy since only a single wire run is needed, which could be sourced from the nearest computer. These characteristics made 10BASE2 ideal for a small network of two or three machines, perhaps in a home where easily concealed wiring was an advantage.
A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router ) are connected with patch cords.
Left, a male RP-TNC connector on a WiFi 2.4GHz antenna. Right, a male TNC connector. Reverse-polarity TNC (RP-TNC, sometimes RTNC) is a variation of the TNC specification which reverses the polarity of the interface.
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers) or two switches to each other.
The component socket accepts a wire lead, such as the lead of a resistor or capacitor, or the leg of a 0.1-inch-pitch DIL package. The insulation-displacement fork accepts an insulated wire specially manufactured for the Speedwire system. The wire is pressed between the forks using a special tool.