Search results
Results from the WOW.Com Content Network
The existing ceiling joists in most houses are only designed to support the weight of a ceiling, therefore additional support will be required to transfer the loads from the new loft floor to the walls of the house, since the alignment of roof supports would generally need to be altered, causing a significant increase in pressure at specific ...
An attic ladder (US) or loft ladder (UK) is a retractable ladder that is installed into an attic door/access panel. They are used as an inexpensive and compact alternative to having a stairway that ascends to the attic of a building. They are useful in areas with space constraints that would hinder the installation of a standard staircase.
A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Louvered attic vent in a gable. Modern building codes permit both vented and unvented attics in all climates, if a building is otherwise correctly constructed. [5] However, unoccupied attics should usually be ventilated [6] to reduce the accumulation of heat and moisture that contribute to mold growth and decay of wood rafters and ceiling ...
In light-frame construction, a trimmer is a timber or metal beam (joist) used to create an opening around a stairwell, skylight, chimney, and the like. Trimmers are installed parallel to the primary floor or ceiling joists and support headers , which run perpendicular to the primary joists.
In the UK, a concrete tiled roof would normally have rafters at 600 mm (24 in) centers, roof battens at 300 mm (12 in) centers and ceiling joists at 400 mm (16 in) centers. The United States still uses imperial units of measurement and framing members are typically spaced sixteen or twenty-four inches apart.
Lime or gypsum plaster is then applied, typically using a wooden board as the application tool. The applier drags the board upward over the wall, forcing the plaster into the gaps between the lath and leaving a layer on the front the depth of the temporary guides, typically about 1 ⁄ 4 inch (6.4 mm). A helper feeds new plaster onto the board ...