Search results
Results from the WOW.Com Content Network
Entropy is one of the few quantities in the physical sciences that require a particular direction for time, sometimes called an arrow of time. As one goes "forward" in time, the second law of thermodynamics says, the entropy of an isolated system can increase, but not decrease. Thus, entropy measurement is a way of distinguishing the past from ...
Owing to these early developments, the typical example of entropy change ΔS is that associated with phase change. In solids, for example, which are typically ordered on the molecular scale, usually have smaller entropy than liquids, and liquids have smaller entropy than gases and colder gases have smaller entropy than hotter gases.
Absolute entropy of strontium. The solid line refers to the entropy of strontium in its normal standard state at 1 atm pressure. The dashed line refers to the entropy of strontium vapor in a non-physical state. The standard entropy change for the formation of a compound from the elements, or for any standard reaction is designated ΔS° form or ...
The maximum entropy principle: For a closed system with fixed internal energy (i.e. an isolated system), the entropy is maximized at equilibrium. The minimum energy principle: For a closed system with fixed entropy, the total energy is minimized at equilibrium.
The entropy of a closed system, determined relative to this zero point, is then the absolute entropy of that system. Mathematically, the absolute entropy of any system at zero temperature is the natural log of the number of ground states times the Boltzmann constant k B = 1.38 × 10 −23 J K −1.
In physics, black hole thermodynamics [1] is the area of study that seeks to reconcile the laws of thermodynamics with the existence of black hole event horizons.As the study of the statistical mechanics of black-body radiation led to the development of the theory of quantum mechanics, the effort to understand the statistical mechanics of black holes has had a deep impact upon the ...
Thermodynamic cycles may be used to model real devices and systems, typically by making a series of assumptions to reduce the problem to a more manageable form. [2] For example, as shown in the figure, devices such a gas turbine or jet engine can be modeled as a Brayton cycle. The actual device is made up of a series of stages, each of which is ...
The T-V diagram of the rubber band experiment. The decrease in the temperature of the rubber band in a spontaneous process at ambient temperature can be explained using the Helmholtz free energy = where dF is the change in free energy, dL is the change in length, τ is the tension, dT is the change in temperature and S is the entropy.