Search results
Results from the WOW.Com Content Network
For the case when the common-base circuit is used as a voltage amplifier, the circuit is shown in Figure 2. The output resistance is large, at least R C || r O, the value which arises with low source impedance (R S ≪ r E). A large output resistance is undesirable in a voltage amplifier, as it leads to poor voltage division at the output.
Single-wire earth return (SWER) or single-wire ground return is a single-wire transmission line which supplies single-phase electric power from an electrical grid to remote areas at lowest cost. The earth (or sometimes a body of water) is used as the return path for the current, to avoid the need for a second wire (or neutral wire ) to act as a ...
The differential pair can be used as an amplifier with a single-ended input if one of the inputs is grounded or fixed to a reference voltage (usually, the other collector is used as a single-ended output) This arrangement can be thought of as cascaded common-collector and common-base stages or as a buffered common-base stage. [nb 3]
The current density, and power dissipated, increases the closer one gets to the ground terminal at the base of the antenna, [14] so the radial ground system can be thought of as providing a higher conductivity medium, copper, for the ground current to flow through, in the parts of the ground carrying high current density, to reduce power losses.
Reactance is defined as the imaginary part of electrical impedance, and is analogous to but not generally equal to the negative reciprocal of the susceptance – that is their reciprocals are equal and opposite only in the special case where the real parts vanish (either zero resistance or zero conductance). In the special case of entirely zero ...
This usually means two distinct metal wires in the circuit, but in the earth-return circuit one of these is replaced by connections to earth (also called ground) to complete the circuit. Connection to earth is made by means of metal plates with a large surface area buried deeply in the ground. These plates could be made of copper or galvanised ...
The ground loop still exists, but the two sides of the loop are close together, so stray magnetic fields induce equal currents in both sides, which cancel out. Break in the shield Create a break in the signal cable shield conductor. [5] The break should be at the load end. This is often called ground lifting. It is the simplest solution; it ...
To arrive at Figure 5, notice that the positive input of the op amp in Figure 3 is at AC ground, so the voltage input to the op amp is simply the AC emitter voltage V e applied to its negative input, resulting in a voltage output of −A v V e. Using Ohm's law across the input resistance r π determines the small-signal base current I b as: