Search results
Results from the WOW.Com Content Network
The Thunder Mustang is a modern 0.75 scale replica of the P-51 Mustang. It has joined the ranks of the high-performance P-51 kits alongside the Titan Aircraft T-51, which has a welded steel airframe with a secondary monocoque aluminum shell, the all-aluminum Stewart S-51D , and the full-scale, turbine-powered Cameron P-51G .
Designed to center-load haul trucks with capacities of up to 360 tonnes (400 short tons), the L-2350 provides an operating payload of 73 tonnes (80 short tons), a 7.03 metres (23.1 ft) lift height, and an 3.5 metres (11.5 ft) reach.
On a standard day, the TBM 940 climbs to FL280 in 17min ½, within 64nmi (119km), for a 7,600ft cabin altitude with the 6.2 psi (0.43 bar) pressurisation, fuel flow is 59 US gallons (223 litres) per hour at maximum cruise power, reaching 304 kn (563 km/h) at ISA +13°C instead of 326 kn (604 km/h) on a standard day. [22]
Titan T-51 Titan T-51. The Titan T-51 Mustang is a three-quarter scale replica of the P-51 Mustang that was designed by Titan Aircraft owner John Williams. It is a two-seat homebuilt aircraft with dual controls and tandem seats, and has remarkable performance given the small size of the engine.
The Historical P-51 Mustang is an American homebuilt aircraft that was designed and produced by the Historical Aircraft Corporation of Nucla, Colorado. The aircraft is a 62.5% scale replica of the original North American P-51 Mustang and when it was available was supplied as a kit for amateur construction.
The V-1710 has often been criticized for not having a "high-altitude" supercharger. The comparison is usually to the later, two-stage, versions of the Rolls-Royce Merlin 60-series engines also built by Packard as the V-1650 and used in the P-51B Mustang and subsequent variants. The USAAC had specified that the V-1710 was to be a single-stage ...
After much consideration at Ford, the Mustang was selected as the platform to offer the highly modified motor in. The Boss 429 engine featured four-bolt main caps, a forged steel crank, forged steel connecting rods, and aluminum cylinder heads with a semi-hemispherical type combustion chamber which Ford called the "crescent".
The Mustang's front suspension makes use of MacPherson struts with longer lower control arms, new spindles, anti-roll bars, and other enhancements over 1993 and older Mustangs. At the rear, a four-bar link solid axle was used. [9] The 1994 Mustang's standard rear axle ratio was 2.73:1, though this was later changed to 3.27:1.