Ads
related to: 5 way binding posts speakers
Search results
Results from the WOW.Com Content Network
A binding post, colored red, which usually indicates a positive terminal. Two insulated, color-coded binding posts at the bottom center of a historical signal generator; modern devices often have bandwidths exceeding the utility of such connectors Adapter between five-way binding posts and a male BNC connector Uninsulated binding posts on a loudspeaker connected to banana plugs Small black ...
Early speaker cable was typically stranded copper wire, insulated with cloth tape, waxed paper or rubber. For portable applications, common lampcord was used, twisted in pairs for mechanical reasons. Cables were often soldered in place at one end. Other terminations were binding posts, terminal strips, and spade
Amplifier and loudspeaker with two elements and crossover networks. Top: normal connection.Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems.
A speaker system has to be wired to accommodate either configuration, typically with two sets of binding posts, one set for the bass and one set for the mid-highs. A single amplifier can usually power a woofer and a tweeter only through a post-amplifier crossover filter, which protects each driver from signals outside its frequency range.
All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.
An N-way loudspeaker usually has an N-way crossover to divide the signal among the drivers. A 2-way crossover consists of a low-pass and a high-pass filter. A 3-way crossover is constructed as a combination of low-pass, band-pass and high-pass filters (LPF, BPF and HPF respectively). The BPF section is in turn a combination of HPF and LPF ...
Number of drivers (complete speaker systems only) – two-way, three-way, etc. Class of loudspeaker: [ 44 ] Class 1: maximum SPL 110–119 dB, the type of loudspeaker used for reproducing a person speaking in a small space or for background music ; mainly used as fill speakers for Class 2 or Class 3 speakers; typically small 4" or 5" woofers ...
The easiest way to remember it is to look at Neutrik part numbers where an "F" indicates Female and an "M denotes Male (eg "NL4FX" is the 'normal' cable connector (with a latch). Speakon connectors are designed to be unambiguous in their use in speaker cables.
Ads
related to: 5 way binding posts speakers