enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Post (structural) - Wikipedia

   en.wikipedia.org/wiki/Post_(structural)

   A single, central post in a roof truss in tension between the rafters and a tie beam (bottom chord), or 2) (U.S.) A short of the tie beam only supporting the rafters via struts. 3) (U.K.) A king post specifically carries a ridge beam otherwise is called a king strut. "King post" was formerly used to describe a crown post in the U. K., but no ...

3. Timber roof truss - Wikipedia

   en.wikipedia.org/wiki/Timber_roof_truss

   Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.

4. Ridge-post framing - Wikipedia

   en.wikipedia.org/wiki/Ridge-post_framing

   Ridge-post framing is an old type of timber framing. The ridge board of their roof is not carried by king posts based on tie beams, but the ridge posts are based on the ground work. The German term for this construction is Firstständerhaus .

5. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

6. Viga (architecture) - Wikipedia

   en.wikipedia.org/wiki/Viga_(architecture)

   An umbral or lintel was added for support of the viga along with vertical posts in these spaces. [12] The porch's roof treatment was the same as in the interior room, but the space provided was used for different purposes. Vigas were usually installed with the smaller ends to one side of the roof to facilitate good drainage. [12]

7. Crown post - Wikipedia

   en.wikipedia.org/wiki/Crown_post

   A crown post is a term in traditional timber framing for a post in roof framing which stands on a tie beam or collar beam and supports a collar plate. [1] Historically, crown posts were called king posts, but this usage is confusing and obsolete. A crown post is designed to be in a compression and transfers weight to the tie beam, where a king ...

8. Ridge vent - Wikipedia

   en.wikipedia.org/wiki/Ridge_vent

   A ridge vent is a type of vent installed at the peak of a sloped roof which allows warm, humid air to escape a building's attic. Ridge vents are most common on shingled residential buildings. Ridge vents are also used in industrial warehouses to help release the hot air and help circulate comfortable air inside the building .

9. Post-and-plank - Wikipedia

   en.wikipedia.org/wiki/Post-and-plank

   Also used to describe log building), corner post construction, post-and-plank, Ständerbohlenbau (German) and skiftesverk (Swedish). This traditional building method is believed to be the predecessor to half-timber construction widely known by its German name fachwerkbau which has wall infill of wattle and daub , brick, or stone.