Search results
Results from the WOW.Com Content Network
A SATA 2.0 (3 Gbit/s) PCI Express ×1 expansion card, having two built-in SATA port multipliers (square chips to the left and right of the middle of PCB) that "splice" card chipset's two SATA ports into a total of eight ports. A Serial ATA port multiplier (SATA PM) is a device that allows multiple SATA devices to be connected to a single SATA ...
Some operating systems, notably Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10, do not configure themselves to load the AHCI driver upon boot if the SATA controller was not in AHCI mode at the time the operating system was installed. Although this is an easily rectifiable condition, it remains an ongoing issue with the AHCI ...
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.
Mechanically, connectors on the host side retain their backward compatibility in a way similar to how USB 3.0 does it – the new host-side SATA Express connector is made by "stacking" an additional connector on top of two legacy standard SATA data connectors, which are regular SATA 3.0 (6 Gbit/s) ports that can accept legacy SATA devices.
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
In Fibre Channel, the port identifier is a WWPN and the device name is a WWNN. In SAS, both SCSI port identifiers and SCSI device names take the form of a SAS address, which is a 64 bit value, normally in the NAA IEEE Registered format. People sometimes refer to a SCSI port identifier as the SAS address of a device, out of confusion. People ...
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.