Search results
Results from the WOW.Com Content Network
Micelles are spheres with a hydrophobic core formed by the non-polar tail of wetting solution molecules and are surrounded by a hydrophilic layer arising from the molecules’ polar heads. [4] Extra wetting solution molecules will be forced to form micelles instead of adhering to the surface, hence the surface tension remains constant.
The sodium adsorption ratio (SAR) is an irrigation water quality parameter used in the management of sodium-affected soils. It is an indicator of the suitability of water for use in agricultural irrigation , as determined from the concentrations of the main alkaline and earth alkaline cations present in the water.
The thermal conductivity is sometimes a constant, otherwise an average value of conductivity for the soil condition between the surface and the point at depth is used. is the temperature difference (temperature gradient) between the two points in the soil between which the heat flux density is to be calculated.
Separate from hydrophobic soils, increased calcium and pH are associated with increased infiltration from improved structure and [[aggregation in biologically active soils. Increasing the soil's pH increases the ability of naturally occurring humic substances to improve infiltration in hydrophobic soils. Humic acid is only water-soluble at a pH ...
For cases where a drug reaches its target locations through passive mechanisms (i.e., diffusion through membranes), the ideal distribution coefficient for the drug is typically intermediate in value (neither too lipophilic, nor too hydrophilic); in cases where molecules reach their targets otherwise, no such generalization applies.
The SAR should not be much higher than 20 and preferably less than 10; When the soil has been exposed to water with a certain SAR value for some time, the ESP value tends to become about equal to the SAR value. The residual sodium carbonate (RSC, meq/L): [5] The formula for calculating the residual sodium carbonate is:
In petrophysics, Archie's law is a purely empirical law relating the measured electrical conductivity of a porous rock to its porosity and fluid saturation. It is named after Gus Archie (1907–1978) and laid the foundation for modern well log interpretation, as it relates borehole electrical conductivity measurements to hydrocarbon saturations.
This page provides supplementary chemical data on sodium chloride. Material safety data sheet ... Dielectric constant, 6.12 at 17–22 °C Bond strength?