enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Instant hot water dispenser - Wikipedia

   en.wikipedia.org/wiki/Instant_hot_water_dispenser

   On the other hand, an instant hot water dispenser without a tank does not waste significant energy. When hot water is needed, the instant heater consumes at least 2000 watts to produce hot water at 92 °C and above. [citation needed] The hot water flow rate is approximately 20 litres per hour. Comparing this with the insulated tank type of hot ...

3. Tankless water heating - Wikipedia

   en.wikipedia.org/wiki/Tankless_water_heating

   Tankless gas electronic ignition water heaters. Gas water heaters have an exhaust vent or one to two exhaust pipes on the top, and still require electric power for electronics, sensing and ignition. A three-phase, 21 kW, 400-volt tankless water heater in Europe, with new European color coding for three-phase power.

4. Water heating - Wikipedia

   en.wikipedia.org/wiki/Water_heating

   Under the pre-2015 standard, a 75 US gal (280 L; 62 imp gal) gas storage water heater with a nominal input of 22 kW (75,000 BTU/h) or less was able to have an energy factor as low as 53%, while under the 2015 standard, the minimum energy factor for a 75-US-gallon gas storage tank water heater is now 74%, which can only be achieved by using ...

5. Storage water heater - Wikipedia

   en.wikipedia.org/wiki/Storage_water_heater

   Solar heat is clean and renewable. This is the most modern system. Increasingly, solar powered water heaters are being used. Their solar thermal collectors are installed outside dwellings, typically on the roof or walls or nearby, and the potable hot water storage tank is typically a pre-existing or new conventional water heater, or a water heater specifically designed for solar thermal.

6. Heat trap - Wikipedia

   en.wikipedia.org/wiki/Heat_trap

   Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the water heater tank, but prevent unwanted natural convection and heated water to flow out of the tank. [1] [2] Newer water heaters have built-in heat traps.

7. Expansion tank - Wikipedia

   en.wikipedia.org/wiki/Expansion_tank

   An expansion tank or expansion vessel is a small tank used to protect closed water heating systems and domestic hot water systems from excessive pressure. The tank is partially filled with air, whose compressibility cushions shock caused by water hammer [citation needed] and absorbs excess water pressure caused by thermal expansion. [1]