enow.com Web Search

  1. Ads

    related to: force outboard power trim parts

Search results

  1. Results from the WOW.Com Content Network
  2. Outboard motor - Wikipedia

    en.wikipedia.org/wiki/Outboard_motor

    Basic parts of an outboard motor. An outboard motor is a propulsion system for boats, consisting of a self-contained unit that includes engine, gearbox and propeller or jet drive, designed to be affixed to the outside of the transom. They are the most common motorised method of propelling small watercraft.

  3. Trim tab - Wikipedia

    en.wikipedia.org/wiki/Trim_tab

    Typical trim tabs on aileron, rudder and elevator. Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a particular desired attitude without the need for the operator to constantly apply a control force.

  4. Elevon - Wikipedia

    en.wikipedia.org/wiki/Elevon

    One of the first operational aircraft to utilise elevons was the Avro Vulcan, a strategic bomber operated by the Royal Air Force's V-force. The original production variant of the Vulcan, designated as the B.1 , did not have any elevons present; instead, it used an arrangement of four inboard elevators and four outboard ailerons along its delta ...

  5. Mercury Marine - Wikipedia

    en.wikipedia.org/wiki/Mercury_Marine

    Mercury outboards 30 hp and below are manufactured by Tohatsu in Japan. [citation needed] Mercury developed a processor-enhanced line of outboards called the "Verado" outboard engine. [when?] [5] The "Verado" system integrates the outboard into an entire system, including "fly-by-wire" steering and advanced diagnostics. Verado engines are ...

  6. Self-steering gear - Wikipedia

    en.wikipedia.org/wiki/Self-steering_gear

    The most widespread form of self-steering, the servo pendulum, was introduced to cope with the power required to operate a larger rudder and was a successor to the servo trim tab principle (introduced by Herbert "Blondie" Hasler). Common to all servo pendulum rudder (oar, blade) systems is the fact, that the speed of the boat through the water ...

  7. Shear pin - Wikipedia

    en.wikipedia.org/wiki/Shear_pin

    A typical example is using shear pins in an explosive device. A shear pin can here hold a striker pin in place, preventing the striker pin from striking an initiator (primer) unless the correct force is applied. That force can be the acceleration of a rifle grenade being launched. The force would snap the shear pin, allowing the striker pin to ...

  1. Ads

    related to: force outboard power trim parts