Ad
related to: 1 8 din chassis punch board
Search results
Results from the WOW.Com Content Network
Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.
Punchboards were often used by the slot-machine machine rackets as a wedge for pushing into communities where slot machines were illegal. [1] Punchboards used for gambling in California in the 1910s were a game "where the player puys for the privilege of inserting a disk in a covered hole on a board and punches out a number, which, if it ...
The width of devices that are mounted on a 35 mm "top hat" DIN rail generally use "modules" as a width unit, one module being 18 mm wide. For example, a small device (e.g. a circuit breaker) may have a width of 1 module (18 mm wide), while a larger device may have a width of 4 modules (4 × 18 mm = 72 mm).
Mentec M100 – Mentec redesign of the 11/93, with J-11 chipset at 19.66 MHz, four on-board serial ports, 1-4 MB of on-board memory, and optional FPU. Mentec M11 – Processor upgrade board; microcode implementation of PDP–11 instruction set by Mentec, using the TI 8832 ALU and TI 8818 microsequencer from Texas Instruments .
Major components on a PICMG 1.3 active backplane Wire-wrapped backplane from a 1960s PDP-8 minicomputer. A backplane or backplane system is a group of electrical connectors in parallel with each other, so that each pin of each connector is linked to the same relative pin of all the other connectors, forming a computer bus.
DIN 41612 was a DIN standard for electrical connectors that are widely used in rack based electrical systems. Standardisation of the connectors is a pre-requisite for open systems, where users expect components from different suppliers to operate together. The most widely known use of DIN 41612 connectors is in the VMEbus and NuBus systems.
Eurocard is an IEEE standard format for printed circuit board (PCB) cards that can be plugged together into a standard chassis which, in turn, can be mounted in a 19-inch rack. The chassis consists of a series of slotted card guides on the top and bottom, into which the cards are slid so they stand on end, like books on a shelf.
DIN 332-1: 60° centre holes; types R, A, B, and C: Active: DIN 332-2: Center holes 60° with thread for shaft ends for rotating electrical machines: Active: DIN 332-4: Centre holes for rail vehicles axles: Active: DIN 332-7: Machine tools; 60° centre holes; dimensioning: Active: DIN 332-8: Centre holes 90°, form S; dimensions, determination ...
Ad
related to: 1 8 din chassis punch board