Search results
Results from the WOW.Com Content Network
Copper tubes are often produced by a cast and roll process. Copper ingots are cast into mother tubes and these tubes are then drawn to a final shape, annealed, and enhanced with an inner surface texture to improve heat transfer performance. The production of small diameter copper tubes requires only the addition of one or two additional drawing ...
Designed to run on the existing 125 W (240 V) series ballast but with a different gas fill and operating voltage, the tube operated at only 100 W. Increased efficiency meant that the tube produced only 9% lumen reduction for a 20% power reduction. [7] This first energy-saving tube design remains a T12 tube even today.
A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [15] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The reduction length is usually equal to the ...
The system is especially well suited to a situation where frequent changes of hoses are required, such as for petroleum trucks, etc. As examples of industrial application, cam and groove fittings can be used in a system where rapid filling of chemical drums takes place, or by factories that have needs of dye, paint, and ink medium transfers.
The 6V6 is a beam-power tetrode vacuum tube. The first of this family of tubes to be introduced was the 6V6G by Ken-Rad Tube & Lamp Corporation in late 1936, [1] with the availability by December of both Ken-Rad and Raytheon 6V6G tubes announced. [2] It is still in use in audio applications, especially electric guitar amplifiers. [3]
A compactron used in television sets to supply power to the anode of the picture tube. This tube is very rare, and very special, because it implements an indirectly heated cathode, not connected to the filament. No data is found on this tube, except for the filament power (which is 3.6 volts, 0.225 amps) and the base (which is the 12GQ type).
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
While Tesla vacuum tubes were exported all over the world, and were known for their quality, the company did not survive the change of economic system after 1989 in combination with the downturn in the vacuum tube market. JJ Electronic was founded in 1993 by Jan Jurco, using the old Tesla machinery for the manufacture of vacuum tubes.