Search results
Results from the WOW.Com Content Network
UFAD systems use an underfloor supply plenum located between the structural concrete slab and a raised floor system to supply conditioned air to supply outlets (usually floor diffusers), located at or near floor level within the occupied space. Air returns from the room at ceiling level or the maximum allowable height above the occupied zone. [1]
A pendulum fan or flap fan is a type of low velocity ceiling fan that can be used for air circulation around a targeted area. The back and forth motion increases turbulence around cooling sources, like chilled waterfalls at the Lavin Bernick Center at Tulane , helping to cool a greater volume of air.
The Pal-Kal method offered an easier, faster, and cheaper solution for casting ceilings compared to traditional reinforced concrete slabs. However, certain applications of this method were proven to be extremely dangerous, and the use of non-standard Pal-Kal ceilings was the main cause of the collapse of the Versailles wedding hall disaster .
Bends in elbows also can accommodate this. Expansion joints also isolate pieces of equipment such as fans from the rigid ductwork, thereby reducing vibration to the ductwork as well as allowing the fan to “grow” as it comes up to the operating air system temperature without placing stress on the fan or the fixed portions of ductwork.
The dowels need to be smooth, round, epoxy and made of bond breaker coated steel conforming to requirements. The bond breaker is to be applied on all surfaces of the dowel bar. The expansion caps belong at each end of the dowel bar and the dowel bar support chairs are used to firmly hold the dowels centered in the slots during backfill operations.
A ceiling can also be the upper limit of a tunnel. The most common type of ceiling is the dropped ceiling, [citation needed] which is suspended from structural elements above. Panels of drywall are fastened either directly to the ceiling joists or to a few layers of moisture-proof plywood which are then attached to the joists. Pipework or ducts ...
A dowel plate. The traditional tool for making dowels is a dowel plate, an iron (or better, hardened tool steel) plate with a hole having the size of the desired dowel.To make a dowel, a piece of wood is split or whittled to a size slightly bigger than desired and then driven through the hole in the dowel plate.
A dropped ceiling is a secondary ceiling, hung below the main (structural) ceiling. It may also be referred to as a drop ceiling, T-bar ceiling, false ceiling, suspended ceiling, grid ceiling, drop in ceiling, drop out ceiling, or ceiling tiles and is a staple of modern construction and architecture in both residential and commercial applications.