Search results
Results from the WOW.Com Content Network
The result is expressed in inches and is usually (but not always) rounded to a convenient fraction. For instance, a 6.4x4.8 mm sensor has a diagonal of 8.0 mm and therefore an optical format of 8.0*3/2 = 12 mm, which is expressed as 1 ⁄ 2 inch in imperial units. The reason it is expressed in inches is historical, dating back to the early days ...
Because the image sensors in many digital cameras are smaller than the 24 mm × 36 mm image area of full-frame 35 mm cameras, a lens of a given focal length gives a narrower field of view in such cameras. Sensor size is often expressed as optical format in inches. Other measures are also used; see table of sensor formats and sizes below.
The alternative Super series, denoted SnR, nR Plus or nR+, has an aspect ratio of 3∶2 (or as close as possible) and thus provides a better fit for standard 135 film (35 mm) at sizes of 8 inches or above. 5R is twice the size of a 2R print, 6R twice the size of a 4R print and S8R twice the size of 6R. 4D/6D is a newer size for most consumer ...
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
For instance the same angle of 0.1 mrad will subtend 10 mm at 100 meters, 20 mm at 200 meters, etc., or similarly 0.39 inches at 100 m, 0.78 inches at 200 m, etc. Subtensions in mrad based optics are particularly useful together with target sizes and shooting distances in metric units. The most common scope adjustment increment in mrad based ...
A USAF 1951 resolution chart in PDF format is provided by Yoshihiko Takinami. This chart should be printed such that the side of the square of the 1st element of the group -2 should be 10 mm long. USAF 1951 Resolution Target Further explanations and examples; Koren 2003: Norman Koren's updated resolution chart better suited for computer analysis
As it is, the Macintosh 128K featured a screen measuring 512 pixels in width by 342 pixels in height, and this corresponded to the width of standard office paper (512 px ÷ 72 px/in ≈ 7.1 in, with a 0.7 in margin down each side when assuming 8 + 1 ⁄ 2 in × 11 in North American paper size; in the rest of the world, it is 210 mm × 297 mm ...
Multiples and submultiples of metric units are related by powers of ten and their names are formed with prefixes. This relationship is compatible with the decimal system of numbers and it contributes greatly to the convenience of metric units. In the early metric system there were two base units, the metre for length and the gram for mass. The ...