Search results
Results from the WOW.Com Content Network
The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60.
The Dana/Spicer model 53 is an automotive rear axle produced by Dana-Spicer used in medium to heavy duty truck applications. The Dana/Spicer model 53 (Dana 53) is a semi-float axle that was produced from 1947–1965, [1] both with a 53 differential and wheel ends, and with a Dana 44 differential and Dana 53 wheel ends.
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford. It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60 .
The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions. 2011 Jeep Dana 30 differential Jeep Dana 30
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.
Down 26-21 with four seconds left, New London-Spicer quarterback Blake Schultz reared back and launched a giant pass from his own 44-yard line, which flew all the way down the field and somehow ...
Tripod joints are used at the inboard end of car driveshafts. The joints were developed by Michel Orain, of Glaenzer Spicer of Poissy, France. This joint has a three-pointed yoke attached to the shaft, which has barrel-shaped roller bearings on the ends. These fit into a cup with three matching grooves, attached to the differential. Since there ...