enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. List of Wi-Fi microcontrollers - Wikipedia

    en.wikipedia.org/wiki/List_of_Wi-Fi_microcontrollers

    Wi-Fi microcontrollers enable Wi-Fi connectivity for devices so that they can send & receive data and accept commands. As such, Wi-Fi microcontrollers can be used for bringing otherwise ordinary devices into the realm of the Internet of things .

  3. ESP8266 - Wikipedia

    en.wikipedia.org/wiki/ESP8266

    SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...

  4. NodeMCU - Wikipedia

    en.wikipedia.org/wiki/NodeMCU

    NodeMCU DEVKIT 1.0, bottom. NodeMCU is a low-cost open source IoT platform. [4] [5] It initially included firmware which runs on the ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which was based on the ESP-12 module.

  5. Hayes AT command set - Wikipedia

    en.wikipedia.org/wiki/Hayes_AT_command_set

    The person at computer B issues the modem escape command. (Alternately, and more commonly, the computer B could drop the DTR, or Data Terminal Ready signal, to achieve a hangup, without needing to use +++ or ATH.) OK: The modem acknowledges it. ATH: The person at computer B issues a hang up command. NO CARRIER: OK

  6. Wi-Fi Direct - Wikipedia

    en.wikipedia.org/wiki/Wi-Fi_Direct

    Intel included Wi-Fi Direct on the Centrino 2 platform, in its My WiFi technology by 2008. [13] Wi-Fi Direct devices can connect to a notebook computer that plays the role of a software Access Point (AP). The notebook computer can then provide Internet access to the Wi-Fi Direct-enabled devices without a Wi-Fi AP.

  7. Command mode and Data mode - Wikipedia

    en.wikipedia.org/wiki/Command_mode_and_Data_mode

    The modem uses the Data Carrier Detect (DCD) pin to signal whether it's connected to a host. The computer can generally just read the DCD pin at any time and always know if the modem is in command or data mode. DCD high means data mode, and low means command mode. DCD is a signal sent from the modem to the computer.

  8. Wireless router - Wikipedia

    en.wikipedia.org/wiki/Wireless_router

    Some wireless routers have one or two USB ports. These can be used to connect printer or desktop or mobile external hard disk drive to be used as a shared resource on the network. [2] A USB port may also be used for connecting mobile broadband modem, [3] aside from connecting the wireless router to an Ethernet with xDSL or cable modem. A mobile ...

  9. Wireless LAN - Wikipedia

    en.wikipedia.org/wiki/Wireless_LAN

    This notebook computer is connected to a wireless access point using a PC Card wireless card. An example of a Wi-Fi network. A wireless LAN (WLAN) is a wireless computer network that links two or more devices using wireless communication to form a local area network (LAN) within a limited area such as a home, school, computer laboratory, campus, or office building.