Search results
Results from the WOW.Com Content Network
A Queued Serial Peripheral Interface (QSPI; different to but has same abbreviation as Quad SPI described in § Quad SPI) is a type of SPI controller that uses a data queue to transfer data across an SPI bus. [19] It has a wrap-around mode allowing continuous transfers to and from the queue with only intermittent attention from the CPU.
The SPI 4.2 interface is composed of high speed clock, control, and data lines and lower speed FIFO buffer status lines. The high speed data line include a 16-bit data bus, a 1 bit control line and a double data rate (DDR) clock. The clock can run up to 500 MHz, supporting up to 1 GigaTransfer per second.
Peripheral Sensor Interface (PSI5) is a digital interface for sensors. PSI5 is a two-wire interface, used to connect peripheral sensors to electronic control units in automotive electronics . Both point-to-point and bus configurations with asynchronous and synchronous data transmission are supported.
An example SPI with a master and three slave select lines. Note that all four chips share the SCLK, MISO, and MOSI lines but each slave has its own slave select. Chip select (CS) or slave select (SS) is the name of a control line in digital electronics used to select one (or a set) of integrated circuits (commonly called "chips") out of several connected to the same computer bus, usually ...
SPI-4.2 is a version of the System Packet Interface published by the Optical Internetworking Forum. It was designed to be used in systems that support OC-192 SONET interfaces and is sometimes used in 10 Gigabit Ethernet based systems.
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.
Goals of the MIPI Sensor Working Group effort were first announced in November 2014 at the MEMS Executive Congress in Scottsdale AZ. [8]Electronic design automation tool vendors including Cadence, [9] Synopsys [10] and Silvaco [11] have released controller IP blocks and associated verification software for the implementation of the I3C bus in new integrated circuit designs.
Low Pin Count interface Winbond chip Trusted Platform Module installed on a motherboard, and using the LPC bus. The Low Pin Count (LPC) bus is a computer bus used on IBM-compatible personal computers to connect low-bandwidth devices to the CPU, such as the BIOS ROM (BIOS ROM was moved to the Serial Peripheral Interface (SPI) bus in 2006 [1]), "legacy" I/O devices (integrated into Super I/O ...