Ad
related to: normalized trigger for dpf regen
Search results
Results from the WOW.Com Content Network
DPF filters go through a regeneration process which removes this soot and lowers the filter pressure. There are three types of regeneration: passive, active, and forced. Passive regeneration takes place normally while driving, when engine load and vehicle drive-cycle create temperatures that are high enough to regenerate the soot buildup on the ...
For this reason, after repeated regeneration events, eventually the DPF must either be physically removed and cleaned in a special external process, or it must be replaced. As noted earlier, the feeding of the low-oxygen exhaust gas into the diesel engine's air intake engenders lower combustion temperatures, thereby reducing emissions of NO x .
DPR is a diesel particulate filtration system with regeneration process that uses late fuel injection to control exhaust temperature to burn off soot. [12] [13] Diesel engines manufactured after January 1, 2010 are required to meet lowered NOx standards for the US market.
Pumped air injection systems use a vane pump called the air pump, AIR pump, or colloquially "smog pump" turned by the engine via a belt or electric motor.The pump's air intake is filtered by a rotating screen or the vehicle air filter to exclude dirt particles large enough to damage the system.
In digital signal processing (DSP), a normalized frequency is a ratio of a variable frequency and a constant frequency associated with a system (such as a sampling rate, ). Some software applications require normalized inputs and produce normalized outputs, which can be re-scaled to physical units when necessary.
The type 36 screen-grid tube (obsolete since the mid-1930s) had a non-regenerative detection gain (audio frequency plate voltage divided by radio frequency input voltage) of only 9.2 at 7.2 MHz, but in a regenerative detector, had detection gain as high as 7,900 at critical regeneration (non-oscillating) and as high as 15,800 with regeneration ...
Some catalytic reforming units have an extra spare or swing reactor and each reactor can be individually isolated so that any one reactor can be undergoing in situ regeneration while the other reactors are in operation. When that reactor is regenerated, it replaces another reactor which, in turn, is isolated so that it can then be regenerated.
Continuous adsorption-electrochemical regeneration encompasses the adsorption and regeneration steps, typically separated in the bulk of industrial processes due to long adsorption equilibrium times (ranging from hours to months), into one continuous system. This is possible using a non-porous, electrically conducting carbon derivative called Nyex.
Ad
related to: normalized trigger for dpf regen