enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Cable gland - Wikipedia

   en.wikipedia.org/wiki/Cable_gland

   Shrouded cable glands going into a flow meter. Split cable gland KVT for routing pre-terminated cables. A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]

3. Cable entry system - Wikipedia

   en.wikipedia.org/wiki/Cable_Entry_System

   Cable entry systems are used for routing electrical cables, corrugated conduits or pneumatic and hydraulic hoses into switch cabinets, electrical enclosures, control panels and machines or in large heavy-duty vehicles, rolling stock and ships. Possible requirements can be high ingress protection rates or integrated strain relief. [1]

4. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   In the case of insulated crimp connectors, the crimped area lies under an insulating sleeve through which the pressing force acts. During crimping, the extended end of this insulating sleeve is simultaneously pressed around the insulated area of the cable, creating strain relief.

5. D-subminiature - Wikipedia

   en.wikipedia.org/wiki/D-subminiature

   Panel-mounted connectors usually have #4-40 UNC (as designated with the Unified Thread Standard) jackscrews that accept screws on the cable end connector cover that are used for locking the connectors together and offering mechanical strain relief, and can be tightened with a 3/16" (or 5mm) hex socket.

6. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   Locking connectors come in a variety of standardized configurations that follow the same general naming scheme except that the designations include an "L" for "locking". Locking connectors are designed so that different voltages and current ratings can not be accidentally intermated. [33] Many specific types exist; only a few are listed below.

7. MC4 connector - Wikipedia

   en.wikipedia.org/wiki/MC4_connector

   Starting in the 2000s, a number of companies introduced products to address these issues. In these systems, the junction box was sealed and two wires were permanently attached using strain reliefs. The cables ended with PV connectors that met the definition of a convenience receptacle, meaning they could be (legally) connected together by anyone.

8. Low pressure molding - Wikipedia

   en.wikipedia.org/wiki/Low_pressure_molding

   The low pressure molding process was initially used in Europe in the 1970s to seal connectors and create strain reliefs for wires. The first commercial use of the low pressure molding process was in the automotive industry.

9. FC connector - Wikipedia

   en.wikipedia.org/wiki/FC_connector

   FC/PC connector. The FC connector is a fiber-optic connector with a threaded body, which was designed for use in high-vibration environments. It is commonly used with both single-mode optical fiber and polarization-maintaining optical fiber. FC connectors are used in datacom, telecommunications, measurement equipment, and single-mode lasers.