enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Synchronization (alternating current) - Wikipedia

   en.wikipedia.org/wiki/Synchronization...

   In an alternating current (AC) electric power system, synchronization is the process of matching the frequency, phase and voltage of a generator or other source to an electrical grid in order to transfer power. If two unconnected segments of a grid are to be connected to each other, they cannot safely exchange AC power until they are synchronized.

3. Polyphase system - Wikipedia

   en.wikipedia.org/wiki/Polyphase_system

   One voltage cycle of a three-phase system. A polyphase system (the term coined by Silvanus Thompson) is a means of distributing alternating-current (AC) electrical power that utilizes more than one AC phase, which refers to the phase offset value (in degrees) between AC in multiple conducting wires; phases may also refer to the corresponding terminals and conductors, as in color codes.

4. Synchroscope - Wikipedia

   en.wikipedia.org/wiki/Synchroscope

   An example of synchroscope operation on a hydroelectric generator. Synchroscopes are used in any power plant that connects to an outside electrical grid and also in isolated plants containing more than one generator. Each generator must be synchronized with the others before being connected to the plant bus. If line voltages are unequal when ...

5. Alternating current - Wikipedia

   en.wikipedia.org/wiki/Alternating_current

   A schematic representation of long distance electric power transmission. From left to right: G=generator, U=step-up transformer, V=voltage at beginning of transmission line, Pt=power entering transmission line, I=current in wires, R=total resistance in wires, Pw=power lost in transmission line, Pe=power reaching the end of the transmission line, D=step-down transformer, C=consumers.

6. Two-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Two-phase_electric_power

   A simplified diagram of a two-phase alternator [1] Two-phase electrical power was an early 20th-century polyphase alternating current electric power distribution system. Two circuits were used, with voltage phases differing by one-quarter of a cycle, 90°. Usually circuits used four wires, two for each phase.

7. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   A transformer supplying a three-wire distribution system has a single-phase input (primary) winding. The output (secondary) winding has a center tap connected to a grounded neutral. As shown in Fig. 1, either end to center has half the voltage of end-to-end. Fig. 2 illustrates the phasor diagram of the output voltages for a split-phase transformer.