enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Shaft collar - Wikipedia

   en.wikipedia.org/wiki/Shaft_collar

   Shaft collar to DIN 705. The shaft collar is a simple, yet important, machine component found in many power transmission applications, most notably motors and gearboxes. The collars are used as mechanical stops, locating components, and bearing faces. The simple design lends itself to easy installation.

3. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   A W-type external-thread collet (red) being pulled into its spindle seat (green) with a drawbar (blue), clamping, rotating and then releasing a shaft. A collet / ˈ k ɒ l ɪ t / is a segmented sleeve, band or collar. [1] [2] One of the two radial surfaces of a collet is usually tapered (i.e a truncated cone) and the other is cylindrical.

4. Boring (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Boring_(manufacturing)

   A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.

5. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   By having twice as many clamping points, a six-jaw chuck induces less than half as much clamping distortion in a thin-walled workpiece, compared to a three-jawed chuck. Two-jaw chucks are available and can be used with soft jaws (typically an aluminium alloy) that can be machined to conform to a particular workpiece.

6. Drawbar (machine tool) - Wikipedia

   en.wikipedia.org/wiki/Drawbar_(machine_tool)

   The drawbar pull is an important component that allows the milling machine to keep the tool in place while it’s being used. The force from the drawbar pull supplied to the tool has to be just right because not enough force would cause the tool to wobble leading to inaccuracy, and too much force would apply excessive stress, leading to shorter tool life.

7. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   Isometric projection of a grub screw with a hex socket head.. Set screws are not always the best way to resist the torque of driven shafts. To reduce the chance of slipping and to increase load capacity, a detent (often called a "flat") may be milled or ground at the part of the shaft where the set screw's point contacts.