Search results
Results from the WOW.Com Content Network
{{convert|100|Mm|mm}} → 100 megametres (1.0 × 10 11 mm) The output of {{convert}} can display multiple converted units, if further unit-codes are specified after the second unnamed parameter (without the pipe separator). Typical combination output units are listed below in column 7. {{convert|55|nmi|km mi}} → 55 nautical miles (102 km; 63 mi)
The applied reinforcement yield stress is = 500 N/mm². The mass density of the reinforcing bars is 7800 kg/m 3. In the table is the computed brittle material stress. is the optimised amount of reinforcement.
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
US/Imperial bar sizes give the diameter in units of 1 ⁄ 8 inch (3.2 mm) for bar sizes #2 through #8, so that #8 = 8 ⁄ 8 inch = 1-inch (25 mm) diameter. There are no fractional bar sizes in this system. The "#" symbol indicates the number sign, and thus "#6" is read as "number six". The use of the "#" sign is customary for US sizes, but "No ...
Hardness Conversion Table – Brinell, Rockwell,Vickers – Various steels . (Archived) (archived November 11, 2011) Rockwell to Brinell conversion chart (Brinell, Rockwell A,B,C)
ACI Code 7.10.4.2: For cast-in-place construction, size of spirals shall not be less than 3/8 in. diameter. ACI Code 7.10.4.3: Clear spacing between spirals shall not exceed 3 in., nor be less than 1in. Section 10.9.3 adds an additional lower limit to the amount of spiral reinforcement via the volumetric spiral reinforcement ratio ρ s.
3% to 6% — similar to your original mortgage. Repayment term. 5 to 30 years. 10-year draw period, followed by a 15- to 20-year repayment period. 15 to 30 years. Payment structure. Fixed monthly ...
The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ratios. Below, these guidelines are explored with examples.