enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Standard RAID levels - Wikipedia

    en.wikipedia.org/wiki/Standard_RAID_levels

    Diagram of a RAID 1 setup. RAID 1 consists of an exact copy (or mirror) of a set of data on two or more disks; a classic RAID 1 mirrored pair contains two disks.This configuration offers no parity, striping, or spanning of disk space across multiple disks, since the data is mirrored on all disks belonging to the array, and the array can only be as big as the smallest member disk.

  3. Nested RAID levels - Wikipedia

    en.wikipedia.org/wiki/Nested_RAID_levels

    The first number in the numeric designation denotes the lowest RAID level in the "stack", while the rightmost one denotes the highest layered RAID level; for example, RAID 50 layers the data striping of RAID 0 on top of the distributed parity of RAID 5. Nested RAID levels include RAID 01, RAID 10, RAID 100, RAID 50 and RAID 60, which all ...

  4. RAID - Wikipedia

    en.wikipedia.org/wiki/RAID

    RAID (/ r eɪ d /; redundant array of inexpensive disks or redundant array of independent disks) [1] [2] is a data storage virtualization technology that combines multiple physical data storage components into one or more logical units for the purposes of data redundancy, performance improvement, or both.

  5. Data striping - Wikipedia

    en.wikipedia.org/wiki/Data_striping

    The amount of data in one stride multiplied by the number of data disks in the array (i.e., stripe depth times stripe width, which in the geometrical analogy would yield an area) is sometimes called the stripe size or stripe width. [5] Wide striping occurs when chunks of data are spread across multiple arrays, possibly all the drives in the system.

  6. Disk array controller - Wikipedia

    en.wikipedia.org/wiki/Disk_array_controller

    Normally, RAID controllers can be fully configured through card BIOS before an operating system is booted, and after the operating system is booted, proprietary configuration utilities are available from the manufacturer of each controller, because the exact feature set of each controller may be specific to each manufacturer and product.

  7. Parity drive - Wikipedia

    en.wikipedia.org/wiki/Parity_Drive

    A parity drive is a hard drive used in a RAID array to provide fault tolerance. For example, RAID 3 uses a parity drive to create a system that is both fault tolerant and, because of data striping, fast. [1] Basically, a single data bit is added to the end of a data block to ensure the number of bits in the message is either odd or even. [2]

  8. Non-standard RAID levels - Wikipedia

    en.wikipedia.org/wiki/Non-standard_RAID_levels

    Under traditional RAID, an entire disk storage system of, say, 100 disks would be split into multiple arrays each of, say, 10 disks. By contrast, under declustered RAID, the entire storage system is used to make one array. Every data item is written twice, as in mirroring, but logically adjacent data and copies are spread arbitrarily.

  9. Intel Rapid Storage Technology - Wikipedia

    en.wikipedia.org/wiki/Intel_Rapid_Storage_Technology

    Linux supports Matrix RAID and Rapid Storage Technology (RST) through device mapper, with dmraid tool, for RAID 0, 1 and 10. And Linux MD RAID, with mdadm tool, for RAID 0, 1, 10, and 5. Set up of the RAID volumes must be done by using the ROM option in the Matrix Storage Manager, then further configuration can be done in DM-RAID or MD-RAID. [10]