Search results
Results from the WOW.Com Content Network
A crew of log buckers with crosscut saws in 1914. [1] Bucker limbing dead branch stubs with a chainsaw, also known as knot bumping Bucker making a bucking cut with a chainsaw Bucking, splitting and stacking logs for firewood in Kõrvemaa, Estonia (October 2022) Bucking is the process of cutting a felled and delimbed tree into logs. [2]
A carpenter uses a chain mortiser to cut a large mortise A worker uses a large circular saw to cut joints. Joinery is a part of woodworking that involves joining pieces of wood, engineered lumber, or synthetic substitutes (such as laminate), to produce more complex items.
Rip cuts are commonly made with a table saw, but other types of power saws can also be used, including a radial arm saw, band saw, and hand held circular saw.In sawmills the head saw is the first rip-saw a log goes through, which is sometimes a gang-saw, and then the cants may be resawn using other saws and then edged in an edger and sometimes cut to length by a crosscut saw.
Quarter-sawn boards have greater stability of form and size with less cupping (compared to flatsawn boards), shrinkage across the width, shake and splitting, and other good qualities. [1] In some woods such as oak, the wood grain produces a decorative effect which shows a prominent ray fleck, while sapele is likely to produce a ribbon figure.
A Humbolt face cut in a Norway maple. The Humbolt face cut is a less well-known felling undercut, and is commonly used in the pacific northwest and pacific coast of Canada and Alaska. [5] A Humbolt face cut has a downward 45 degree angle, and allows the directional face cut to be made out of the stump rather than the log.
Lumber can be quickly flat-cut with a side-by-side set of mechanical saws. [3] A slower but sturdier method involves passing the log back and forth over a single saw. To reduce buckling that may occur along the middle of flat-cut boards, the initial cut may be offset from the diameter, and resulting sections cut further before cutting the flitches.
The cutting edge of each tooth is angled in an alternating pattern. This design allows each tooth to act like a knife edge and slice through the wood in contrast to a rip saw, which tears along the grain, acting like a miniature chisel. Some crosscut saws use special teeth, called rakers, designed to clean out the cut strips of wood from the ...
In woodworking, a cut made at (or close to) a right angle to the direction of the wood grain of the workpiece. A crosscut saw is used to make this type of cut. Rip cut In woodworking, a cut made parallel to the direction of the grain of the workpiece. A ripsaw is used to make this type of cut. Plytooth blade