Search results
Results from the WOW.Com Content Network
The pitch of a helix is the height of one complete helix turn, measured parallel to the axis of the helix. A double helix consists of two (typically congruent) helices with the same axis, differing by a translation along the axis. [3] A circular helix (i.e. one with constant radius) has constant band curvature and constant torsion. The slope of ...
The efficiency can be plotted versus the helix angle for a constant friction, as shown in the adjacent diagram. The maximum efficiency is a helix angle between 40 and 45 degrees, however a reasonable efficiency is achieved above 15°. Due to difficulties in forming the thread, helix angle greater than 30° are rarely used.
In these screws, the lead is equal to the pitch multiplied by the number of "starts". Lead angle is the angle between the helix and a plane of rotation. It is the complement of the helix angle, and is used for convenience in worms and hobs. It is understood to be at the standard pitch diameter unless otherwise specified.
the plane normal to the pitch helix at side of tooth; the plane normal to the pitch helix at center of tooth; the plane normal to the pitch helix at center of space between two teeth; In a spiral bevel gear, one of the positions of a normal plane is at a mean point and the plane is normal to the tooth trace. [1]
In mathematics, a conical spiral, also known as a conical helix, [1] is a space curve on a right circular cone, whose floor projection is a plane spiral. If the floor projection is a logarithmic spiral , it is called conchospiral (from conch ).
In the axial mode or end-fire helical antenna, the diameter and pitch of the helix are comparable to a wavelength. The antenna functions as a directional antenna radiating a beam off the ends of the helix, along the antenna's axis. It radiates circularly polarized radio waves. These are used for satellite communication.
Thread limit or pitch diameter limit is a standard used for classifying the tolerance of the thread pitch diameter for taps. For imperial, H or L limits are used which designate how many units of 0.0005 inch over or undersized the pitch diameter is from its basic value, respectively.
The trace of the point is a circular helix (red). It is contained in the surface of a right circular cylinder. Its radius is the distance of point to the z-axis. In case of >, the helix is called right handed; otherwise, it is said to be left handed.