Search results
Results from the WOW.Com Content Network
FTDI US232R : USB to RS-232 cable. A USB-to-serial adapter or simply USB adapter is a type of protocol converter that is used for converting USB data signals to and from serial communications standards (serial ports). Most commonly the USB data signals are converted to either RS-232, RS-485, RS-422, or TTL-level UART serial data.
It is based on RS-232 serial communications at 9600 bit/s, 8N1, no flow control typically though a DE-9 connector, but can also be on 8-Pin DIN, RJ45 and RJ11 connectors used in daisy chain configurations. [1] VISCA utilizes a serial repeater network configuration to communicate between the PC (device #0) and up to 7 peripherals (#1 through #7).
The drivers for a software-implemented modem create a virtual serial port for communication with the host operating system, since the modem is implemented entirely in the device driver and therefore there is no point where the serial data would be sent to the physical card.
At a lower level, a device driver implementing these functions would communicate to the particular serial port controller installed on a user's computer. The commands needed to control a 16550 UART are much different from the commands needed to control an FTDI serial port converter, but each hardware-specific device driver abstracts these ...
COM (communication port) [1] [2] is the original, yet still common, name of the serial port interface on PC-compatible computers. It can refer not only to physical ports, but also to emulated ports, such as ports created by Bluetooth or USB adapters .
This class can be used for industrial equipment such as CNC machinery to allow upgrading from older RS-232 serial controllers and robotics, since they can keep software compatibility. The device attaches to an RS-232 communications line and the operating system on the USB side makes the USB device appear as a traditional RS-232 port.
Frequent use of a serial port is for a direct computer-to-computer connection. This requires an adapter called a null modem, which isn't actually a modem in the traditional sense, but rather a connector plug that simply crosses the complementary pins on two serial ports so the two sides can communicate. A null modem typically connects the DTR ...
In 1989, HP developed their TML language [10] which was the forerunner to SCPI. The IEC developed their own standards in parallel with the IEEE, with IEC 60625-2-1993 (IEC 625). In 2004, the IEEE and IEC combined their respective standards into a "dual logo" IEEE/IEC standard IEC 60488-2-2004 , Part 2: Codes, Formats, Protocols and Common ...