Search results
Results from the WOW.Com Content Network
A very small low-power dummy load such as a ceramic power resistor or 10-watt light bulb can be attached to the supply to allow it to run with no primary load attached. The switch-mode power supplies used in computers have historically had low power factors and have also been significant sources of line interference (due to induced power line ...
Typically, bulbs of 21 to 27 watts producing 280 to 570 lumens (22 to 45 mean spherical candlepower) are used for stop, turn, reversing and rear fog lights, while bulbs of 4 to 10 W, producing 40 to 130 lm (3 to 10 mscp) are used for tail lights, parking lights, side marker lights and side turn signal repeaters. [citation needed]
10 mm: 5 mm Twist-lock 120/230-volt MR16 halogen lighting of 35/50 watt, since the mid-2000s. Also used for compact fluorescents and LED lamps. GZ10: 7004-120-1: 10 mm: Twist-lock 120/230-volt MR16 halogen lighting of 35/50 watt, differs from GU10 by use of a dichroic reflector. GZ10 fixtures can use GU10 bulbs, but not vice versa. G12: 7004-63 ...
The wires are usually inserted into a plastic base that the bulb is mounted in, and which is often narrower at the tip than at the bulb, giving it a wedge shape and usually ensuring a tight connection, depending on manufacturing tolerances. Some bulbs have no plastic base, and the wires are simply bent up to the sides of the bulb's glass base.
These lamps use a bi-pin connector for power: 12-volt MR11 bulbs usually use a GU4 base, and 12-volt MR16 bulbs usually use a GU5.3 base. The common 12-volt MR16 lamps, therefore, require a ferromagnetic or electronic transformer —sometimes misnamed as a ballast —to convert the 120- or 230-volt mains voltage to the extra-low voltage ...
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A 10-ampere-hour battery could take 15 hours to reach a fully charged state from a fully discharged condition with a 1-ampere charger as it would require roughly 1.5 times the battery's capacity. Public EV charging stations often provide 6 kW (host power of 208 to 240 V AC off a 40-ampere circuit). 6 kW will recharge an EV roughly six times ...