Search results
Results from the WOW.Com Content Network
Increased heat transfer due to the secondary flow is not significant in turbulent state constituting less than 10% for /. Furthermore, augmentation created by the use of helically coiled tubes due to the secondary flow is usually employed only for situations where the flow is in the laminar state.
In shell-and-tube heat exchangers there is a potential for a tube to rupture and for high pressure (HP) fluid to enter and over-pressurise the low pressure (LP) side of the heat exchanger. [8] The usual configuration of exchangers is for the HP fluid to be in the tubes and for LP water, cooling or heating media to be on the shell side.
The member companies of TEMA must demonstrate high quality exchanger fabrication standards, and possess in-house engineering capability for mechanical and thermal design of shell and tube type heat exchangers. Companies may fabricate other equipment in addition to heat exchangers. The current member companies of TEMA (in alphabetical order) are:
Pages in category "Heat exchangers" The following 39 pages are in this category, out of 39 total. ... Concentric tube heat exchanger; Condenser (heat transfer)
An alternative to the earth-to-air heat exchanger is the "water" to earth heat exchanger. This is typically similar to a geothermal heat pump tubing embedded horizontally in the soil (or could be a vertical sonde) to a similar depth of the earth-air heat exchanger. It uses approximately double the length of pipe of 35 mm diameter, e.g., around ...
Shell and tube heat exchangers consist of a tube bundle which is placed inside the larger shell. [2] Due to this design these exchanger require twice the footprint of the plate heat exchanger in order to perform maintenance. Depending on the amount of cooling needed, shell and tube heat exchangers can be built in single or double pass ...
It is used in some household stoves [1] and in some industrial process vessels (tanks), such as shell and tube heat exchangers, chemical reactors, and static mixers. Baffles are an integral part of the shell and tube heat exchanger design. A baffle is designed to support tube bundles and direct the flow of fluids for maximum
Concentric Tube (or Pipe) Heat Exchangers are used in a variety of industries for purposes such as material processing, food preparation, and air-conditioning. [1] They create a temperature driving force by passing fluid streams of different temperatures parallel to each other, separated by a physical boundary in the form of a pipe.