enow.com Web Search

  1. Ads

    related to: metric rod ends

Search results

  1. Results from the WOW.Com Content Network
  2. Threaded rod - Wikipedia

    en.wikipedia.org/wiki/Threaded_rod

    A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the rod. [1] They are designed to be used in tension. [2] Threaded rod in bar stock form is often called all-thread (ATR); other names include fully-threaded rod, redi-rod, continuously-threaded rod ...

  3. Level staff - Wikipedia

    en.wikipedia.org/wiki/Level_staff

    The metric rod has major numbered graduations in meters and tenths of meters (e.g. 18 is 1.8 m - there is a tiny decimal point between the numbers). Between the major marks are either a pattern of squares and spaces in different colours or an E shape (or its mirror image) with horizontal components and spaces between of equal size.

  4. Rod (unit) - Wikipedia

    en.wikipedia.org/wiki/Rod_(unit)

    The rod, perch, or pole (sometimes also lug) is a surveyor's tool [1] and unit of length of various historical definitions. In British imperial and US customary units , it is defined as 16 + 1 ⁄ 2 feet , equal to exactly 1 ⁄ 320 of a mile , or 5 + 1 ⁄ 2 yards (a quarter of a surveyor's chain ), and is exactly 5.0292 meters.

  5. List of moments of inertia - Wikipedia

    en.wikipedia.org/wiki/List_of_moments_of_inertia

    Thin cylindrical shell with open ends, of radius r and mass m. This expression assumes that the shell thickness is negligible. It is a special case of the thick-walled cylindrical tube for r 1 = r 2. Also, a point mass m at the end of a rod of length r has this same moment of inertia and the value r is called the radius of gyration.

  6. Taper pin - Wikipedia

    en.wikipedia.org/wiki/Taper_pin

    Metric taper pins have a taper of 1:50. [1] A 1:50 taper means that one end of a 50 mm long bar will be 1 mm smaller in diameter than the other end. Inch-sized taper pins have a slightly smaller taper taper on diameter of 1:48 [ 2 ] A 1:48 taper means that one end of a 4-foot-long bar (48 inches) will be 1 inch smaller in diameter than the ...

  7. Rod end bearing - Wikipedia

    en.wikipedia.org/wiki/Rod_end_bearing

    A rod end bearing, also known as a heim joint (N. America) or rose joint (U.K. and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links , tie rods , or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect 90-degree alignment between the ...

  1. Ads

    related to: metric rod ends