Search results
Results from the WOW.Com Content Network
In computing and in embedded systems, a programmable interval timer (PIT) is a counter that generates an output signal when it reaches a programmed count. The output signal may trigger an interrupt .
A watchdog timer (WDT, or simply a watchdog), sometimes called a computer operating properly timer (COP timer), [1] is an electronic or software timer that is used to detect and recover from computer malfunctions. Watchdog timers are widely used in computers to facilitate automatic correction of temporary hardware faults, and to prevent errant ...
RTC_A/B are 32-bit hardware counter modules that provide clock counters with a calendar, a flexible programmable alarm, and calibration. The RTC_B includes a switchable battery backup system that provides the ability for the RTC to operate when the primary supply fails. 16-bit timers; Timer_A, Timer_B and Timer_D are asynchronous 16-bit timers ...
The PSoC 4 features a 32-bit ARM Cortex-M0 CPU, with programmable analog blocks (operational amplifiers and comparators), programmable digital blocks (PLD-based UDBs), programmable routing and flexible GPIO (route any function to any pin), a serial communication block (for SPI, UART, I²C), a timer/counter/PWM block and more.
In addition to the converters, many embedded microprocessors include a variety of timers as well. One of the most common types of timers is the programmable interval timer (PIT). A PIT may either count down from some value to zero, or up to the capacity of the count register, overflowing to zero.
A prescaler is an electronic counting circuit used to reduce a high frequency electrical signal to a lower frequency by integer division.The prescaler takes the basic timer clock frequency (which may be the CPU clock frequency or may be some higher or lower frequency) and divides it by some value before feeding it to the timer, according to how the prescaler register(s) are configured.
This frequency, divided by 2 16 (the largest divisor the 8253 is capable of) produces the ≈18.2 Hz timer interrupt used in MS-DOS and related operating systems. In the original IBM PCs, Counter 0 is used to generate a timekeeping interrupt. Counter 1 is used to trigger the refresh of DRAM memory. Counter 2 is used to generate tones via the PC ...
The Joint Test Action Group feature provides access to on-chip debugging functionality while the chip is running in the target system. [27] JTAG allows accessing internal memory and registers, setting breakpoints on code, and single-stepping execution to observe system behaviour. Atmel provides a series of JTAG adapters for the AVR: