Ads
related to: 4 1/2 inch pipe clamp wall mount anchors for aluminumtemu.com has been visited by 1M+ users in the past month
- Where To Buy
Daily must-haves
Special for you
- Best Seller
Countless Choices For Low Prices
Up To 90% Off For Everything
- Crazy, So Cheap？
Limited time offer
Hot selling items
- Xmas Deals Inside
Limited time offer
Hot selling items
- Where To Buy
Search results
Results from the WOW.Com Content Network
A deep channel 1 + 5 ⁄ 8 in × 2 + 7 ⁄ 16 in (41 mm × 62 mm) version is also manufactured. The material used to form the channel is typically sheet metal with a thickness of 1.5 mm or 2.5 mm (12 or 14 gauge; 0.1046 inch or 0.0747 inch, respectively). [2] Types of channel
A pipe anchor is a rigid support that restricts movement in all three orthogonal directions and all three rotational directions, i.e. restricting al the 6 degrees of freedom This usually is a welded stanchion that is welded or bolted to steel or concrete. [2] In case of anchor which is bolted to concrete, a special type of bolt is required ...
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
A pipe clamp is a type of clamp often employed in piping, woodworking, and cabinet shops. Pipe clamps for woodwork or cabinet shops are usually composed of commercially manufactured clamp heads or "jaws" and a length of common threaded pipe. [1] [2] The capacity of the clamp is determined by the length of the pipe used.
Screw clamps are normally used for hoses 1/2 inch diameter and up, with other clamps used for smaller hoses. The first patent for a worm-drive hose clamp was granted to Swedish inventor Knut Edwin Bergström [ se ] in 1896 [ 1 ] Bergström founded “Allmänna Brandredskapsaffären E. Bergström & Co.” in 1896 (ABA) to manufacture these worm ...
Ads
related to: 4 1/2 inch pipe clamp wall mount anchors for aluminumtemu.com has been visited by 1M+ users in the past month